Iniciar sesión:
Votos - , Puntuación media: ( )

Manual de usuario HP, modelo HP SAN Virtualization Services Platform Base Starter Kit

Fabricar: HP
Tamaño del archivo: 214.92 kb
Nombre del archivo:

Idioma del manual:en

El documento se está cargando, por favor, espere
El documento se está cargando, por favor, espere


Otros manuales para este modelo:

Resumen del manual








Attach rails to the Data Path Module
Install rails to cabinet
1.
Remove the two 4–40 x 0.25 flat head screws from both sides of
1.
Assemble each inner cabinet mounting rail with an outer cabinet
the Data Path Module. The screws are located toward the Power
mounting rail. Use four 6–32 x 0.38 flat head screws in each rail
Cooling Module (PCM).
assembly. In some applications you can use five 6–32 x 0.38 flat
head screws. Insert the screws through the outer rail into the
captured nuts in the inner rail. Do no tighten the screws at this time.
10–32 x 0.38 flat head
1
Data Path Module rails
3
screws
6–32 x 0.38 flat head
1
Outer cabinet mounting rail
3
4–40 x 0.25 flat head
screws
2
screws
2
Inner cabinet mounting rail
2.
Position one rail on each side of the Data Path Module. The rail is
correctly positioned when you can reinstall a 4–40 x 0.25 flat head
screw through the tab in the rail.
WARNING!
Heavier products should be placed near the bottom of
a cabinet. A top-heavy cabinet can become unstable,
resulting in equipment damage or personal injury.
2.
Extend the cabinet rails to fit the inner dimensions of the cabinet.
The rail flanges on both ends fit inside the cabinet. Be sure that the
3.
Reinstall a 4–40 x 0.25 flat head screw through the tab in each
inner rail is toward the PCM end of the Data Path Module (which
rail.
is the air intake end).
4.
Secure the rails to the Data Path Module using two 10–32 x 0.38
flat head screws in each rail.
Install the support bracket to the Data
Path Module
1.
Remove the existing PCM retaining bracket.
2.
Install the support bracket in place of the PCM retaining T-bracket.
It is important that the support bracket be installed while the DPM
is laying fully on a flat surface. There should be no flexing or bowing
of the chassis when the support bracket is secure.
1
Cabinet rail
3
Centering washer
10–32 x 0.38 pan head
2
screw
3.
Fasten the rail assemblies to the cabinet. Insert two 10–32 x 0.38
pan head screws through the cabinet and into the upper and lower
captured nuts in each rail flange (eight total screws for both rail
assemblies).
1
Data Path Module
2
Support bracket
4.
Tighten the 6–32 x 0.38 flat head screws in each rail assembly that
were installed in step 1.
Page 2


...

Otros modelos de este manual:
Software - HP SAN Virtualization Services Platform Business Copy SW 1TB 101-250TB E-LTU (214.92 kb)
Software - HP SAN Virtualization Services Platform Continuous Access SW 1TB 0-15TB E-LTU (214.92 kb)
Software - HP SAN Virtualization Services Platform Extension Pair Data Path Module (214.92 kb)
Software - HP SAN Virtualization Services Platform Hardware Bundle (214.92 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría