Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
43-491 OWNER’S MANUAL Please read before using this equipment. 2-Station Wireless FM Intercom 43-491.fm Page 2 Friday, August 13, 1999 9:58 AM FEATURES Your RadioShack 2-Station Wireless FM Intercom is an advanced one-channel intercom system that is convenient and easy to use. Installation is quick and simple. Simply plug each of the two supplied stations into a standard AC outlet, and you’re ready to send and receive calls or to monitor an area where a station is installed. Each of your intercom’s stations has the following features: Precision PLL Circuit — provides clear and stable communications. Built-in Frequency Modulation Circuit — reduces line noise and interference. Call Tone — alerts the other station before you start talking. Lock — lets you set a station for monitoring or other one- way communication. Power Indicator — lights to show that the station is on. Talk Indicator — lights to let you know when you are transmitting to the other station. Expandable — you can add additional stations. © 1997 Tandy Corporation. All Rights Reserved. RadioShack is a registered trademark used by Tandy Corporation. 2 RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICE- ABLE PARTS INSIDE. REFER SERVIC- ING TO QUALIFIED PERSONNEL. WARNING: To reduce the risk of fire or shock hazard, do not ex- pose this product to rain or mois- ture. CAUTION ! 43-491.fm Page 3 Friday, August 13, 1999 9:58 AM RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICE- ABLE PARTS INSIDE. REFER SERVIC- ING TO QUALIFIED PERSONNEL. WARNING: To reduce the risk of fire or shock hazard, do not ex- pose this product to rain or mois- ture. CAUTION ! 43-491.fm Page 3 Friday, August 13, 1999 9:58 AM ! This symbol is intended to alert you to the presence of uninsulated dangerous voltage within the product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock. Do not open the product’s case. This symbol is intended to inform you that important operating and maintenance instructions are included in the literature accompanying this product. The graphical symbols with supplemental markings are on the bottom of the unit. 3 43-491.fm Page 4 Friday, August 13, 1999 9:58 AM INSTALLATION You can install the stations almost anywhere there is a standard AC outlet. Simply plug each station into an AC outlet, then place it directly on a desk, shelf, or table, or mount it on a wall. Important: • You must connect all of the stations to AC outlets connected to the same phase of a power line transformer. All AC outlets in most residential and many commercial properties are connected to the same phase of a power line transformer. • Stations can transmit up to 300 feet and between buildings as long as they are connected to the same phase of a power line transformer. • Make sure you install the stations at least 10 feet away from each other. Placing the stations too close together produces feedback which creates a squealing sound. Caution: To prevent electric shock, one blade on the power cord’s plug is wider than the other so the plug fits into the outlet only one way. If you cannot easily insert the plug, turn it over and try again. Do not force it. 4 43-491.fm Page 5 Friday, August 13, 1999 9:58 AM MOUNTING THE STATIONS To mount a station on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the stations. Follow these steps to mount a station on the wall. 1. Mark the mounting screw locations 29/16 inches (65.08 mm) apart, one above the other. 2. Drill a hole at each marked location. 3. Thread a screw into each hole until the screw’s head extends about 1/8 inch from the wall. 4. Align the keyhole slots on the bottom of the station with the screw heads in the wall, then slide the station down to secure it. 5 43-491.fm Page 6 Friday, August 13, 1999 9:58 AM OPERATION TURNING A STATION ON AND OFF/ ADJUSTING THE VOLUME Rotate VOLUME to the left until it clicks. The station’s POWER indicator lights. Then rotate VOLUME left or right to increase or decrease the volume level. To turn off the station, rotate VOLUME to the right until it clicks. CALLING ANOTHER STATION 1. Be sure the stations you plan to use are turned on and adjusted to the desired volume. 2. Press CALL. A tone sounds at the other station(s). 6 43-491.fm Page 7 Friday, August 13, 1999 9:58 AM 3. Hold down TALK and speak in a normal voice. The station’s TALK indicator lights. When you finish speaking, release TALK and listen for the response. Notes: • Only one party can talk at a time. Wait until the other party finishes before answering. • The TALK indicator on the station you are using remains lit as long as you hold down TALK or CALL, or when you press LOCK (see “Monitoring” on Page 8). • If your voice sounds distorted, you might be speaking too loudly or too close to th...