Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
The intercoms form an exclusive network and respond only to other intercoms in the network. Intercom (2 in Model RWIS) 1 Rubber Pads (2 in Model RWIS) Operation & Features Channel Button: Press the Channel button to set intercom to one of four secure channels or the paging channel. The default channel for the intercom is the paging channel where all four channel lights are lit. An intercom on a channel can only hear an intercom on the same channel or on the paging channel. Volume: Pressing the Volume button repeatedly will cycle through volume levels. Battery: The AA Alkaline batteries (not provided) will last up to a year depending on use (Lithium batteries recommended for colder environments). When batteries are low intercom will emit two beeps every ten minutes. An AC Adapter (not provided) can also be used to power the intercom. In this case, both the power and channel lights will remain on. Conference Mode: Conference Mode allows multiple intercoms to participate in a conversation compared to Normal Mode in which only two intercoms can communicate. All intercoms must be set to the same channel or the paging channel to be in Conference Mode. To put intercom in Conference Mode set Dipswitch #2 to UP position. Monitor Mode: Monitor Mode is used to monitor the sound in a specific room. Place the intercom in the room that is to be monitored and press and hold the Talk and Volume buttons until a tone is heard. Any other networked intercom can listen to that room. If a specific channel is selected for Monitor Mode then only other intercoms on that channel or on the paging channel can listen. When in Monitor Mode, the intercom will stay active for 15 minutes then will shut off to conserve battery power. The Channel light will begin to flash while in Standby Mode and the intercom will reactivate for an additional 15 minutes when a sound is heard from the room being monitored. Voice Activation Mode (VOX): Voice Activation Mode (VOX) allows a call to be answered without pressing the Talk button. Once a call is heard on an intercom which has been set to VOX, a response can be given by speaking loudly into the intercom. There will be a slight delay when VOX is first activated by a voice, but will continue to transmit audio until the speaking stops. To put intercom into VOX, place Dipswitch #1 to the UP position. Volume Button Talk (Power - On) Channel Button Learn Button Dipswitch #1 Dipswitch #2 AC Adapter Wireless Portable Intercom ® On/Off: To turn intercom ON, press any button. To turn intercom OFF, hold down the Volume button for 5 seconds. Talk Button: To talk, hold down the Talk button. All intercoms in the network that are on the same channel will receive the signal. Release the Talk button when done talking and within 10-15 seconds press and hold the Talk button of a different intercom to make a secure channel between the two. Once the channel is made the other intercoms in the network cannot hear the conversation. 1 2 1 2 Microphone Channel Lights OPTIONAL Assemble Intercom Step 1 Step 2 Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments.) Programming Intercom Adhere rubber pads to bottom. Repeat Steps 1 and 2 for any additional intercoms. The intercom must be programmed to at least one other intercom to become a network or it can be programmed into an existin...
Otros modelos de este manual:Teléfonos fijos - CARTON INVENTORY RWIA (277.75 kb)