Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Twist the exposed strands. Note: The removable connectors accept up to 14 gauge wire. 2. Loosen the set screws on the volume control. 3. Connect the leads from your amplifier to the volume control set screws labeled INPUT. Make sure the LEFT L(+) and L(-) and RIGHT R(+) and R (-) wires are inserted in the appropriately marked opening. Then, tighten the screws. 4. Connect your speaker wires to the volume control set screws labeled OUTPUT, observing the + (positive) and - (negative) polarity of left and right speaker. 5. Set up the completed assembly in the junction box. Insert the assembly carefully to avoid excessive strain on the set screws. If necessary, pre-dress the wires. 6. Set up to receive IR: Loosen the connector screws. Insert the corresponding wires. Then, tighten the screws. “ V+” -12VDC power “ G ” - Grounding “IR” -IR signal 7. Mount the VSIR100 into wall box and screw on the face plate. Volume set at maximum Impedance jumper settings to match 8i2 at amplifier SPEAKER OHMS (Q) 1X 2X 4X 8X 8 1 PAIR 2 PAIR 4 PAIR 8 PAIR 4 - 1 PAIR 2 PAIR 4 PAIR Impedance jumper settings to match 4i2 at amplifier SPEAKER OHMS (Q) 1X 2X 4X 8X 8 2 PAIR 4 PAIR 8 PAIR 16 PAIR 4 1 PAIR 2 PAIR 4 PAIR 8 PAIR Jumper settings bomm S8EK8K nn flfl nr nr inr s§ts6 X8 000003 SSKKSK oooooc SIEKSK X4 Assembly diagram Mounting depth: 2.48” (63mm) from finished wall. Connection diagram Remote - controllable IR volume control (VSIR100W/VSIR100B) LEFT SPEAKER Caution Do not allow speaker wire strands to short out against the case or other speaker wires. ©2007 Audiovox Accessories Corporation 111 Congressional Blvd., Suite 350 Carmel, IN 46032 Remote-Controllable Infrared Volume Control VSIR100WA/SIR1OOB OWNERS MANUAL...