Installation 1. Choose a mounting location on the instrument panel that will allow enough room behind the panel to run the wired remote cables to the existing radio. 2. Cut a hole in the instrument panel using the supplied template. At least 2 ." depth is needed to mount the remote control. Important: Do not mount unit where it can be submerged or subjected to high pressure spray. 3. Insert the remote control into the rubber foam gasket and then into the hole in the instrument panel. Secure from

2. Remove the two screws on the base that appear when the remote is removed. 3. Position strap around steering wheel, and pull tight. Replace plate and screws. 4. Insert battery (Lithum 2032 3-volt) into remote contol, and reinstall theremote onto the base/strap. VR185 Infrared Sensor 3.5 mm Jack (21/64 hole or 9.2 mm drill Installing the IR Sensor Select a mounting location close to the steering wheel, and drill a 21/64 hole for the 3.5 mm. jack to pass through. Route the infrared sensor wire t