Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
It gives you important instructions on safety, use, and maintenance of the appliance. Please keep these instructions in a safe place and pass them on, if necessary, to the next owner. Safety Instructions for the user ■ This appliance meets the radio interference suppression requirements of EC Directive 82/499 EC and 87/308 EG, EN 55014/DIN VDE 0875 Part 1, as well as the standards concerning the reverse effects of electrical appliances on the power mains EN 60555 Parts 1-3/DIN VDE 0838 Parts 1-3, of June 1987. ■ This appliance must only be connected to the same mains voltage as shown on the rating plate. ■ The circuit of the socket used must be protected with a fuse of at least 13 A. ■ Before maintenance or cleaning, ensure that the appliance is switched off and unplugged from the mains supply. ■ Never use the flex to pull the mains plug out of the plug socket. ■ Do not operate the appliance if: - the flex is damaged - the housing shows visible signs of damage. ■ Avoid running over the flex with the appliance, cleaning head or electric power cleaning head. ■ Ifnopaperduatbag is inserted the cover cannot be dosed. Please do not use force! ■ Make sure a paper dustbag, a MICROFILTER, and a motor protection filter are always inserted. ■ This vacuum cleaner should only be used for normal dry household dust and dirt It must not be used on people or animals. Keep children away from electrical appliances. The manufacturer cannot be held responsible for any damage caused by use or operation of the appliance contrary to these instructions. ■ Allow fitted carpets that have been shampooed to dry out completely. Never use your vacuum cleaner to vacuum liquids, otherwise it may be damaged. There is also a risk of an electric shock. ■ Never use your appliance to vacuum matches, glowing embers, or cigarette-ends. Avoid vacuuming hard, pointed objects, since they may damage the appliance or paper dustbag. ■ If the flex is defective, the complete flex rewind unit should be replaced by your AEG Service Centre or an authorised AEG Service Agent ■ Repairs to electrical appliances should only be carried out by a trained electrician. Improper repairs may place the user at serious risk. ■ If your vacuum cleaner has a fault, please contact your electrical retailer or the AEG Service Centre direct ■ If the appliance is wrongly operated for a purpose other than that for which it is intended, no liability can be accepted for any possible damage. 16 2/BI 9/91 GBÆU - 2/S2 9/91 GB/EU 2/S2 9/91 GB/EU Important for users in the UK The wires in the mains lead of this appliance are coloured in accordance with the following code: BLUE-neutral BROWN-live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, PROCEED AS FOLLOWS: The wire which is coloured BROWN must be connected to the terminal which is marked L or coloured RED. The wire which is coloured BLUE must be connected to the terminal which is marked N or coloured BLACK! If a 13 amp plug is fitted, fit a 13 amp BS1362 fuse. Ifany other type of plug is used, protect with a 15 amp fuse at the distribution board. For appliances which come with mains lead and plug moulded on: the plug moulded on to the cord incorporates a fuse. For replacement use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse cover/carrier must be replaced in the event of changing the fuse. The plug must not be used if the fuse cover/carrier is lost A replacement cover/carrier must be obtained from authorised electrical goods retailers. WARNING Should it become necessary to replace the moulded on plug then the defective plug should be destroyed. 17 Assembling the vacuum-cleaner ready for use The hose, tubes and accessories can be fitted together by pushing and twisting, and taken apart by twisting and pulling. Fitting the suction hose and suction tube together Push the tube end of the hose firmly into the suction tube. Adjusting the telescopic tube Slide the button on the tube downwards and set the tube at the most convenient fength for working with. When the button is released the telescopic tube is engaged in the position you require. Connecting the suction hose Insert the hose holder into the suction opening. When the hose is to be disconnected from the appliance, press the release button and pull the hose holder out of the suction opening. 18 2/SBM1 9/91 GB/EU - 2/SBM2 9/91 GB/EU - 2/SBM4 9/91 GB/EU - 2/SBM5 9/91 GB/EU 2/SBM6 9/91 GB/EU - 2/AD1 9/91 GB/EU - 2/AD2 9/91 GB/EU - 2/AD4 9/91 GB/EU Mains connection/Rex rewind The mains cable is located in the cable compartment. Press the foot button for the cable, and pull the cable out. Insert the plug into the socket. At the end of vacuuming switch off and pull the plug out of the socket. Press the flex rewind button and the cable rewinds automatically. Using the cleaning head and accessory ...