Votos - 3, Puntuación media: 3.7 ( )

Fabricar: Samsung Tamaño del archivo: 382.51 kb Nombre del archivo: Idioma del manual:

The Post-Motor Filter assists in the filtation process to return clean air to the room. It is located behind the door on the front of the Cleaner. When the filter becomes dirty, open the door, remove the filter and shake the dust off the filter.The Post- Motor Filter is non-washable therefore do not wash it in water. Replace the door by inserting the tabs on the left side and snapping the right side into place. Do not operate cleaner without Either the Pre-Motor Filter or Post-Motor Filter in place. Grasp the Circular Filters and twist to unlock Pull straight up to remove. Separate the Outer foam and Inner pleated Circular Filters. Wash each individually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry Thoroughly dry before putting them back together and replacing in the Filter Cup The Filter Cup may be washed In warm water with a mild detergent. Make sure it is completely dry before reassembling with fliters. 4 Maintenance 3-7 3-9 3-10 3-11 3-12 3-13 The belt 3-8 The belt on your cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace Disconnect cleaner from electrical outlet. To check belt, remove bottom plate as shown in “How to replace.” Replace belt if it is stretched, cut or broken. With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B). Reposition bottom plate and 4 screws. Tighten screws securely. How to replace Disconnect cleaner from electrical outlet. Place handle in low position and turn cleaner over so bottom side is up. Remove the 4 screws as shown with a screw driver. Insert agitator through belt and place belt in belt guide (C) on agitator. Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown, noting the placement of its belt guide (D) When to replace the agitator brush roll When agitator brushes are worn, the agitator should be replaced. To check condition of brushes, disconnect cleaner from electrical outlet. Move the edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, replace agitator if brushes do not touch card. Remove agitator and used belt. Discard used belt. Grasp agitator firmly and fit it into position by first sliding the end opposite the belt into the rectangular slot (F) on side of cleaner. Pull other side of agitator (G) into place. Turn agitator, making sure belt is not pinched between agitator and agitator shield. How to replace Disconnect cleaner from electrical outlet. Remove bottom plate, belt and agitator following directions in “The belt” section beginning with Fig. 3-10. Discard old agitator. Continue following the directions in “The belt” section to reposition belt, new agitator and bottom plate. 5 Maintenance Clearing Blockag...

Descargar ahora

Introduzca dos números de la imagen: