Votos - 1, Puntuación media: 5
(
)
)
|
Resumen del manual
Clean the cord off to prevent heavy soiling and cleaning residues from building up on the cord. This is a good time to inspect the cord for cuts, gashes and loose prongs. Tip the machine back and remove the pad and the drive block or brush. The condition of the floor pad or brush has a direct affect on the performance of your floor machine. When the pad becomes dirty, turn it over and use the other side. When finished, wash the pad or brush and allow it to dry completely before using it again. Stand the wet brush on the bristles until dry, then hang up the brush. Do not store the machine with the drive block, pad or brush on the machine. Wipe off the machine housing and wheels to prevent build-up of unnecessary residue. TRANSPORTING THE MACHINE Place the handle in the upright position. Lock the handle cam release lever. Tip the machine back and transport on the wheels. MAINTENANCE FOR THE P201, P203, P171, P173, P131, P201HD, P171HD, P202 and P172 Once a month remove the motor cover of the unplugged machine by pulling evenly, but firmly, with both hands until the cover is removed. Vacuum out any dust or debris which has accumulated on the motor. Replace the motor cover by setting it over the holes in the housing and firmly pushing it down. Check and maintain the tightness of all the fasteners. WARNING: Do not over-tighten the switch housing screws. Picture #4 Speed Switch Keep the machine clean especially at the handle tube and collar so the handle tube will move freely through the collar. Inspect the cord for cuts, gashes, or loose prongs; replace as needed. Disassembly of this motor voids the warranty. Improper disassembly and assembly of this motor can permanently damage the field or rotor. For P202 & P172 only: The length of the carbon brushes should be inspected annually. If they are no longer extended past the holder window, they should be replaced. Replacement of the carbon brushes should only be done by a qualified service technician. TROUBLESHOOTING SAFETY INSTRUCTIONSAFETY INSTRUCTIONS Machine does not run. The circuit breaker has tripped. Allow the circuit breaker 2 minutes to cool before resetting. Plug is broken or has loose contact. Replace. Prevent circuit overload. Check the pad and change it if it is rough or dirty. Spray buffing or spray cleaning is not a substitute for scrubbing or mopping a floor. Prepare the floor surface before spray buffing. Eliminate any extension cord that is smaller than 12/3 wire or greater than 25 feet in length. Unplug anything other than the machine from the circuit or locate another circuit. Machine will not start. Circuit breaker is not reset. Reset breaker. Plug is broken or has a loose contact. Replace. Circuit breaker is defective or weak. Replace. Switch is defective. Replace switch. Rectifier is defective. Replace rectifier (P202 and P172 only). Machine will not reach operating speed. Unplug anything else other than the machine from the circuit or locate another circuit. Motor runs but pad or brush does not turn. Coupling is broken. Replace. Coupling is not covered under warranty. Do not attempt to place a running machine over a block or brush. Always place and remove the block or brush by hand. This Floor Machine should be grounded while in use to protect the operator from electric shock. This machine is equipped with a 3conductor cord and a 3-prong grounded type attachment cap plug to fit the proper grounding type receptacle. The green (...
Otros modelos de este manual:Aspiradoras - Standard And High Speed Floor Machine P201 (83.49 kb)
Aspiradoras - Standard And High Speed Floor Machine P201 (83.49 kb)
Aspiradoras - Standard And High Speed Floor Machine P201 (83.49 kb)
Aspiradoras - Standard And High Speed Floor Machine P201 (83.49 kb)