Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
100% playability cannot be guaranteed. This is not an indication of a problem with the player. IMPORTANT: THIS MODEL HAS A MOTORIZED ELECTRONIC CD DOOR. DO NOT ATTEMPT TO OPEN THE DOOR MANUALLY. THIS COULD CAUSE DAMAGE TO THE DOOR OPENING MECHANISM. 1.) Slide the CD/RADIO selector switch on the top cabinet to the CD position. 2.) Press the STANDBY/ON button on the front panel or on the remote control (Model CKD2330 only). The display will show two flashing dashes (“- -“) in the track number display. After a few seconds the track number display will show “00”, indicating that there is no disc in the player. 3.) Press the OPEN/CLOSE button on the front panel or on the remote control (Model CKD2330 only) once. IMPORTANT! THERE WILL BE A PAUSE OF APPROXIMATELY TWO SECONDS BEFORE THE POWER PANEL OPENS. PLEASE WAIT. DO NOT PRESS THE OPEN/CLOSE BUTTON AGAIN. 18 CKD2328_2330_B091103.p65 18 11/9/2003, 14:51 19 4.) The Power Panel will rotate 90 degrees to allow you to load your disc in the CD player. Before loading your own disc be sure to remove the dummy CD transit card from the player and discard it. 5.) Place your disc on the center spindle with the printed label side facing you. Gently press on the disc near the center hole to insure that the disc is properly ‘seated’ on the spindle. 6.) Press the OPEN/CLOSE button on the front panel or on the remote control (Model CKD2330 only). The Power Panel will return to its closed position. The disc will spin for a few seconds while the player reads the TOC (Table of Contents) on the disc. Then the disc will stop spinning and the display will show the total number of tracks on the disc. CKD2328_2330_B091103.p65 19 11/9/2003, 14:51 7.) Press the PLAY/PAUSE button on the front panel or on the remote control (Model CKD2330 only). Playback begins on track 1 and the PLAY indicator appears in the display. PLAY Adjust the VOLUME controls to the desired level. 8.) Playback will continue until the last track has played then the disc stops, the PLAY indicator disappears, and the display again shows the total number of tracks on the disc. To stop playback before the disc ends press the STOP button on the front panel or on the remote control (Model CKD2330 Only) at any time. The disc stops and the display shows the total tracks on the disc. 9.) If you are finished listening press the OPEN/CLOSE button on the front panel or on the remote control (Model CKD2330 Only), wait for the two-second delay before the Power Panel opens. When the panel opens, gently remove your disc from the player, and then press the OPEN/CLOSE button again to close the Power Panel. 10.) To listen to the radio slide the CD/RADIO selector switch back to the Radio position, or press the STANDBY/ON button to return the system to the Standby (Power Off) mode. 20 CKD2328_2330_B091103.p65 20 11/9/2003, 14:51 PAUSE Control To pause momentarily during CD playback press the PLAY/PAUSE button on the front panel or on the remote control (Model CKD2330 only) again. The sound stops and the PLAY indicator flashes but the disc continues to spin. PLAY Press the PLAY/PAUSE button again to cancel the Pause mode and resume normal playback. The sound resumes at the same point on the disc and the PLAY indicator stops flashing. SKIP/SEARCH Controls ( / ) During playback press the SKIP Forward or SKIP Reverse buttons on the front panel or on the remote control (Model CKD2330 Only) repeatedly to skip forward or back to higher or lower numbered tracks. Playback will start at the beginning of the selected track. To search within a track for a specific musical passage depress and hold the SKIP Forward or SKIP Reverse buttons on the front panel or on the remote control (Model CKD2330 Only). The player will search rapidly forward or backward as long as the buttons are depressed. When you hear the desired passage release the buttons and normal playback will resume at that point. To start playback from a specific track load your disc as usual and wait until the display shows the total number of tracks. Press the SKIP Forward or SKIP Reverse buttons repeatedly until the desired track number appears in the display then press the PLAY/PAUSE button to begin playback on the desired track. 21 CKD2328_2330_B091103.p65 21 11/9/2003, 14:51 SPECIAL PLAYBACK MODES REPEAT Playback You can program the player to continuously repeat a single track or the entire disc. The Repeat mode can be selected while the disc is playing or while the disc is stopped. Single Track Repeat Select the track to be repeated and then press the REPEAT button on the front panel once. The REPEAT indicator begins flashing in the display. If necessary, press the PLAY/PAUSE button to begin playback. The selected track will be repeated continuously. REPEAT PLAY All Tracks Repeat Press the REPEAT button on the front panel twice. The REPEAT indicator remains in the display. If necessary, press the PLAY/PAUSE button to begin playback. The entire disc will be repeated continuously. REPEA...
Otros modelos de este manual:Los receptores de radio - CKD2330 (457.71 kb)