Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
CD PLAYBACK 1. Insert a CD with the printed side facing up, and close the door. 2. Press PLAY/ PAUSE 2; to start playback. y Display shows: 'Cd: --' and the total number of tracks, then your current track number, before returning to clock time. Other possible CD indications before returning to clock time: y door is shown if the CD door is not closed. y noCd is shown if no CD has been inserted / inserted incorrectly. y nFCd is shown if the CD-R(W) is nonfinalized y Err indicates a general error in operation of the set. 3. Adjust the sound with 4 or 3. 4. To interrupt, press 2; y CD icon flashes. 5. Press 2; again to resume playback. 6. Press ALARM RESET to stop playback. Note: If CD playback is paused for more than 15 minutes and no controls are pressed, the set automatically goes to standby mode. Selecting a different track during playback The track number appears briefly in the display when you press °or ¤to skip tracks. • Press ¤once or more to skip to the next track(s). • Press °once and playback will return to the beginning of the current track. • Press °more than once to skip to previous tracks. Alarm time display If you have set both alarms, the standby alarm time display will show the earlier of the two alarm times as priority. E.g. if AL1 = 6:00 and AL2 = 5:45, then the standby alarm display will show the AL2 time 5:45. CD/ RADIO SETTING ALARM OPTIONS Finding a passage within a track 1. During playback, press and hold down °or ¤ y The CD is played at high speed and low volume; the display will show 'Cd:' and your current track number. 2. Release °or ¤when you recognize the passage you want. y Normal CD playback and standby clock time resumes. RADIO 1. Press RADIO ON (FM/ AM) to switch on the radio. y Display shows 'tu' before returning to clock time. 2. Press RADIO ON (FM/ AM) again if you wish to change waveband. 3. Adjust the sound using 4 or 3 4. Adjust the TUNING wheel to tune to a radio station. To improve reception: FM: Extend coil antenna at the back of the unit fully for optimum reception. AM: Uses a built-in antenna. Direct the antenna by adjusting the position of your set. 5. Press ALARM RESET to switch off. SETTING THE ALARM OPTIONS GENERAL Two different alarm times, AL 1 and AL 2 can be set in the CD, radio or buzzer modes. Selecting the Alarm Mode Options When selected, the selected alarm mode is shown in the display, and the respective AL 1 or 2 button lights up. 1. Select your choice of alarm mode. Either press briefly: • AL1 once for CD alarm . This enables CD playback from the first track as your alarm call. • AL2 once or more for radio / buzzer alarm 2. Read the following section if you want to select the WAKE-UP TRACK alarm option. Selecting CD WAKE-UP Alarm Mode You can program and select a CD track number between 1-99, when the set is in the standby or radio playback mode. However, if the track number programmed does not exist on your CD, the CD will start playback from the first track during the alarm call. 1. Set the alarm time for AL1. 2. Insert a CD into the CD compartment. 3. Press AL 1 to select CD alarm mode. 4. Press WAKE-UP TRACK to activate favorite track programming. 5. Press °or ¤ until the desired track number is shown. 6. Press WAKE-UP TRACK to confirm the selected track number. y The display returns to standby clock time. 7. If you want to review your programmed track number, press WAKE-UP TRACK Note: • The buzzer alarm option will automatically replace the CD alarm if you have: – inserted a CD incorrectly; – inserted a damaged CD; – forgotten to insert any CD; – not closed the CD door properly. Radio Alarm: If you have selected the radio alarm, make sure you have tuned properly to a station. AL TIME 2 Gentle Wake Volume A sure way of getting up in the mornings, the gentle wake volume for the alarm begins from a fixed gentle volume (10) and gradually increases to a maximum higher setting of ( 25.) • The default low volume is Lo : 10, and the maximum volume is HI : 25. • During the alarm call, if you press 4 or 3, the volume stops increasing immediately. • The gentle wake volume settings do not affect normal CD and radio playback volume level, unless you have pressed 4 or 3during the alarm call. SWITCHING OFF THE ALARM There are three ways to switch off the alarm. Unless you cancel the alarm completely, the 24 HOUR ALARM RESET will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET. y You will hear a beep tone to confirm the 24 hour alarm is reset. REPEAT ALARM This will repeat your alarm call at 9-minute intervals. • During the alarm call, press REPEAT ALARM/ BRIGHTNESS CONTROL. • Repeat if desired up to an hour. Note: • The selected alarm mode , or indicators flashes throughout the repeat alarm duration. • If you are using the CD alarm mode, CD playback resumes at ...
Otros modelos de este manual:Relojes - AJ3970 (218.56 kb)