Votos - , Puntuación media: ( )

Manual de usuario Allstar Products Group, modelo 9931MT

Fabricar: Allstar Products Group
Tamaño del archivo: 468.12 kb
Nombre del archivo:

Idioma del manual:

El documento se está cargando, por favor, espere

Descargar ahoraCerca

El documento se está cargando, por favor, espere

Descargar ahoraCerca

The LED will blink off once and then remain on. Go to Step 3. .. - ENTER YOUR 9 DIGIT CODE 3. Enter the 9- digit code from the table pressing the buttons that correspond with the grid above. (If your block has 8 switches use the + button in the 9th position) Go to Step 4. .. 4. After the 9- digit code is entered, the LED will blink twice to confirm a valid code and remain off. 5. Repeat the procedure for the remaining buttons. INSTRUCTIONS FOR USE WITH AN ALLSTAR SMART RECEIVER When using the Allstar Classic with a Smart Receiver there is no need to match a switch setting. Simply make up your own unique code, enter it in the grid on page 2 and follow the instructions starting with Step 1. When the transmitter is programmed, follow the instructions for teaching the receiver the transmitter code. Note: If you want to program all the buttons you can Express Code them by selecting the + button in Step 2 and ending the 9 position code in Step 3 with a + . This will code all three buttons in one programming step. IMPORTANT The SAME CODE must be set on both the transmitter and receiver. The controls will not function if the codes are mismatched. Keep transmitters and remote controls out of the reach of children. Do not let children play with or use the transmitter or remote controls. Unexpected door operations can cause personal injury or property damage. Do not place transmitter where the buttons can be accidentally or unintentionally activated. WARNING Installing the Transmitter Battery Replacement The transmitter is The MVP Quik-Code transmitter is provided with two supplied with a metal factory installed 3- volt batteries which should be clip which may be used replaced after two years of normal use. The transmitter to attach the unit to a code is retained in permanent memory and will not be sun visor. If the clip is lost during battery replacement. To replace the used, slide it into the batteries, remove the back of the case with a small recess provided on the screwdriver. Carefully slip the batteries out of the back of the transmitter holders and replace with fresh CR2032 3- volt batteries. case until the snaps on the case fit around the clip. The “+ ” on the batteries must point away from the If the transmitter is installed in a pocket in your car, circuit board. Replace the back of the cover and resume follow all the manufacturer’s instructions. normal use. Improper transmitter installation or use may cause intermittent operation which canresult in unexpected operations. ...