Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
NOTE: Voice commands are recognized in English only Package contents • Clock radio • AC power adapter • AAA alkaline batteries (3) • User Guide • Quick Setup Guide Speakers and microphone LCD display Top view Volume up button Volume down button Record button Snooze/sleep/voice command button Back view Setting up your clock radio Installing the backup batteries 1 Open the battery compartment cover located on the bottom of your clock radio. 2 Insert three “AAA” batteries, checking that the polarity (+ and - ends of the batteries) matches the drawing inside the battery compartment. We recommend the use of alkaline batteries for longer life. 3 Close the battery compartment cover. Connecting the AC power adapter 1 Plug the small DC power connector into the DC IN 9V jack on the back of your clock radio. 2 Plug the AC adapter into an AC power outlet. NOTE: Remove both the DC plug and the AC-IN plug to disconnect the AC power adapter when not in use. Use only the supplied AC power adapter to power your clock radio. /source button Tune down button Tune up button Preset button DC in jack VC On/Off button AUX in jack Alarm 2 button FM antenna (wire) Alarm 1 button Dimmer button Minute button Time set button Hour button Actual product may vary from image shown. Getting started Setting the clock 1 Press and hold the TIME SET button on the back of your clock radio. The time blinks on the LCD. 2 Press MIN (minute) to set the minutes and HOUR to set the hours. Make sure that you set AM/PM correctly. 3 Press TIME SET again. The clock is set. Turning your clock radio on and off 1 Press and hold /SOURCE for two seconds. Your clock radio turns on. 2 Press DIMMER on the back of your clock radio to set the display backlight of the LCD to a comfortable level. 3 Press and hold /SOURCE again to switch your clock radio to standby mode. Using Voice Command 1 Turn the VC button to ON on the back of the radio. To activate the voice controls, say “Voice Command” to the clock radio or press the SNOOZE/ SLEEP/ VOICE COMMAND button. The clock will respond “What can I do for you?.” TIPS: • Speak clearly and in a normal tone. • Give correct commands (refer to command list below). • Do not give commands when the clock radio is speaking. • Speak near the microphone located on the top of the clock radio. • Commands must be spoken in non-accented English. 2 Say any of the following commands for the function you want, then follow the voice prompts carefully: • Time (”tim”) • Set Time (”set tim”) Setting and using the alarm manually 1 Press and hold the ALARM 1 or ALARM 2 button (depending on which alarm you want to set) until the display blinks. 2 Press HOUR to set the hour you want to wake up, then press MIN (minute) to set the minute. Make sure you set AM/PM correctly. 3 Briefly press ALARM 1 or ALARM 2 again to save the setting. The display stops blinking. 4 To cancel the alarm, press ALARM 1 or ALARM 2 again until the alarm indicator disappears from the display. Playing the radio 1 Press and hold the /SOURCE button for two seconds to turn on your clock radio. • Press the /SOURCE button repeatedly to select the AM or FM band. • If you are listening to FM, uncoil and extend the FM antenna on the back of your clock radio and move it around to improve reception. -OR- If you are listening to AM, turn the radio slightly to improve reception. • Press TUNE + or TUNE -to tune the radio to a higher or lower frequency. • Press and hold TUNE + or TUNE -for more than one second to scan to a higher or lower frequency. The radio automatically scans to the next station. • Press the VOLUME UP or VOLUME DOWN buttons to increase or decrease the volume. Adjust the volume to a comfortable level. Specifications Frequency range Bands: FM and AM Range: FM - 87.5~107.9 MHz (200 KHz steps) AM - 530~1710 KHz (10 KHz steps) Station presets FM - 5 AM - 5 External connections 3.5 mm stereo Volume 0-16 levels Speakers 2 x 2" - 4 ohm full range 2W x 2 RMS Power AC power adapter - 110V 60Hz to 9V,1A DC - 3 x AAA batteries for memory backup Troubleshooting For information on troubleshooting, refer to the User Guide. FCC Part 15 This device complies with Part 15 of the FCC Rules. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment. ICES-003 Class B Notice This Class B digital apparatus complies with Canadian ICES-003. e e -’larm”) • Set Alarm (”set • Alarm (” 2 Press and hold the /SOURCE button to turn off your clock radio. -’larm”) • Sleep Time (”slep tim”) Listening to an external sound source 1 Make sure that your clock radio is turned off. • Radio (”ra-de-o”) 2 Connect the external sound source to the AUX IN jack on the back of your • Help (”help”) clock radio using a stereo 3.5 mm plug cord (not supplied). e l”) [Pronunciation guide derived from online Merriam-Webster dictionary at radio. 4 Press the • Cancel (”kan(t)-s 3 P...