Votos - 3, Puntuación media: 4 ( )

Fabricar: A & T International Tamaño del archivo: 1.87 mb Nombre del archivo: Idioma del manual:

The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. The telephone base comes ready for tabletop use. If you want to mount your telephone on a wall, refer to Wall mount installation in the user’s manual for details. Electrical outlet not controlled by a wall switch Telephone wall jack A DSL filter (not included) is required if you have DSL high-speed Internet service. Plug the small end of the larger power adapter into the power jack on the back of the telephone base. Plug one end of the telephone line cord into the TEL. LINE jack on the back of the telephone base. Route the cords through the slot. Plug the other end of the telephone line cord into a telephone wall jack. Plug the large end of the larger power adapter into an electrical outlet not controlled by a wall switch. Telephone line cord Plug the large end of the smaller power adapter into an electrical outlet not controlled by a wall switch. Raise the antenna. IMPORTANT INFORMATION: Use only the power adapters provided with this product. To obtain a replacement, visit our website at or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if they are plugged into a ceiling or an under-the-table or cabinet outlet. Route the cord through the slot. Ensure the small end of the smaller power adapter is plugged into the power jack on the back of the charger. Battery installation and charging Battery installation Install the battery as shown below. Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. Insert the supplied battery with the label THIS SIDE UP facing up as indicated. Align the cover flat against the battery compartment, then slide it upwards until it clicks into place. Charge the handset by placing it face forward in the telephone base or charger. The CHARGE light is on when charging. CHARGE light To replace the battery, press the tab and slide the battery compartment cover downwards. Lift out the old battery and disconnect it from the handset. Follow the instructions above to install and charge the new battery. IMPORTANT INFORMATION: Use only the supplied rechargeable battery or replacement battery (model BT166342). To order, visit our website at or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. Battery installation and charging Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. If the screen is bla...

Descargar ahora

Introduzca dos números de la imagen: