|
Resumen del manual
The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual. These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer’s warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage. U.K. MAINS PLUG WARNING A molded mains plug that has been cut off from the cord is unsafe. Discard the mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover in place. Replacement fuse covers can be obtained from your local retailer. Replacement fuses are 13 amps and MUST be ASTA approved to BS1362. Safety Instructions (European) Notice For Customers If Your Unit Is Equipped With A Power Cord. WARNING: THIS APPLIANCE MUST BE EARTHED. The cores in the mains lead are colored in accordance with the following code: GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live As colors of the cores in the mains lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: • The core which is colored green and yellow must be connected to the terminal in the plug marked with the letter E, or with the earth symbol, or colored green, or green and yellow. 1 2SR Series • The core which is colored blue must be connected to the terminal marked N or colored black. • The core which is colored brown must be connected to the terminal marked L or colored red. These units comply with the European “EMC Directive” for emissions and susceptibility. The power cord is terminated in a CEE7/7 plug (Continental Europe). The green/yellow wire is connected directly to the unit's chassis. If you need to change the plug, and if you are qualified to do so, refer to the table below. CONDUCTOR WIRE COLOR Normal Alt L LIVE BROWN BLACK N NEUTRAL BLUE WHITE E EARTH GND GREEN/YEL GREEN WARNING: If the ground is defeated, certain fault conditions in the unit or in the system to which it is connected can result in full line voltage between chassis and earth ground. Severe injury or death can then result if the chassis and earth ground are touched simultaneously. IMPORTANT! FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: Water and Moisture: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWERSOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. SERVICING: The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. SR Series 3 INTRODUCTION Congratulations, and thank you for your purchase of DOD equalization components. DOD equalizers are versatile, cost-effective equalization tools for the musician, performer, studio engineer, and sound contractor. Each equalizer allows the user to see a graphic representation of the equalization applied to the audio spectrum, and offers the flexibility to provide solutions to many EQ problems. The units offer up to 12 dB of cut or boost per band with a switchable low cut filter for each channel. Electronic switching of these functions minimizes switching transients (loud pops or clicks when the switch is depressed), and up to ±12 dB of level control is available to compensate for gain changes due to equaliza- tion. This feature makes A/B comparisons of the equalized signal to the original signal quick and easy. Connection to the equalizer may be either balanced with an XLR connector or with optional unbalanced 1/4" phone plug making the units readily interfaceable to any system. Dual channel units may be used as a ...
Otros modelos de este manual:El receptor y el amplificador - SR430QXLR (198.13 kb)
El receptor y el amplificador - SR831QXLR (198.13 kb)
El receptor y el amplificador - SR830ZXLR (198.13 kb)
El receptor y el amplificador - SR 231QX, SR 430QX, SR 431QX, SR 830QX, SR 831QX (198.13 kb)