Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Speaker Connections Depending on the type and number of speakers used with the amplifier, wire them to the speaker terminals as per the appropriate wiring diagram. For most applications, #18 gauge wire should be used for the speaker leads but in no case thinner than #20 gauge. For leads in excess of 10 feet, #16 gauge is recommended. When wiring the speakers, pay careful attention to the polarity of the terminals on the speakers and make certain they correspond to the polarity of the corresponding terminals on the amplifier. DO NOT ground any speaker leads to the chassis of the vehicle. 5. Input Connections This amplifier features both high and low-level input capability. Use either the low-level or high-level inputs, not both. If low-level outputs are provided from the car stereo, it is recommended that the low-level inputs be used for lowest distortion and best performance. Use good quality shielded audio cables with RCA plugs at both ends to connect the stereo to the amplifier and keep the cable lengths to a minimum to avoid noise. If the car stereo does not provide low-level outputs, the amplifier may be connected via the speaker (high-level) outputs from the stereo. Wire the speaker leads from the car stereo to the 5-pin adaptor harnesses as shown in the diagram (shielded cable is not required for this application) and plug the connectors into the mating High-Level Input socket on the amplifier. Carefully splice and insulate all wire connections. CAUTION: Use either the low-level or the high-level inputs on the amplifier. DO NOT use both input levels at the same time. -5 -6INPUT WIRING DIAGRAM IMPORTANT USE EITHER HIGH-LEVEL OR LOW-LEVEL INPUT, NOT BOTH. CAR STEREO HIGH-LEVEL (SPEAKER) INPUT (WIRE SIDE VIEW) LOW-LEVEL INPUT RCA TYPE SHIELDED EXTENSION CABLES (NOT INCLUDED) 12 Gray Brown Black Green White HI-INPUTHI-INPUT GNDGND L +L + R +R + LL RR MINMIN MAXMAX GAINGAIN RR LL PWRPWR Left Right -6INPUT WIRING DIAGRAM IMPORTANT USE EITHER HIGH-LEVEL OR LOW-LEVEL INPUT, NOT BOTH. CAR STEREO HIGH-LEVEL (SPEAKER) INPUT (WIRE SIDE VIEW) LOW-LEVEL INPUT RCA TYPE SHIELDED EXTENSION CABLES (NOT INCLUDED) 12 Gray Brown Black Green White HI-INPUTHI-INPUT GNDGND L +L + R +R + LL RR MINMIN MAXMAX GAINGAIN RR LL PWRPWR Left Right WARNING! NEVER COMBINE (BRIDGE ) OUTPUTS FOR USE WITH 2 SPEAKER. NEVER GROUND NEGATIVE SPEAKER LEADS TO CHASSIS GROUND. FAILURE TO WIRE CORRECTLY MAY CAUSE DAMAGE TO THE AMPLIFIER. EXISTING SCREW OR BOLT CLEAN PAINT, RUST, DIRT OUTPUT WIRING DIAGRAM RIGHT SPEAKER GROUND METAL SECTION OF VEHICLE OR GREASE FROM AREA FOR GOOD CONNECTION. F FF U UU S SS E EE 3 BATT REM GND RIGHT LEFT GROUND USE # 16 GAUGE WIRE CAR STEREO BATTERY FOR 12 VOLT USE ONLY AUTO-ANTENNA LEAD LEFT SPEAKER -7 Power Indicator Lamps The Power Indicator Lamps will light to indicate that the unit is connected to the battery and that the Remote Turn-On terminal is receiving +12 volts, thus turning on the amplifier. After initial set-up, the amplifier should not require any further adjustment unless there is a change in the car stereo or speaker system with which it is used. 3 1 2 OPERATION HI-INPUTHI-INPUT GNDGND L +L + R +R + LL RR MINMIN MAXMAX GAINGAIN RR LL PWRPWR FUSFUS REMBATT GND LEFTRIGHT 3 12 3 1 2 OPERATION HI-INPUTHI-INPUT GNDGND L +L + R +R + LL RR MINMIN MAXMAX GAINGAIN RR LL PWRPWR FUSFUS REMBATT GND LEFTRIGHT 3 12 Level (Gain) Controls The amplifier is capable of operating from sources supplying a wide range of input levels. The Level controls should initially be set to the mid-rotation position. If it is found that there is not enough output even when the volume control on the car stereo is at its maximum setting, adjust the Level control to increase the output from the system.If, however, there is still output from the amplifier when the car stereo volume control is at its minimum setting, orthe output level increases too fast with a small rotation ofthe volume control, adjust the Level control to decrease the output from the system. Once the correct setting is found, these controls should not require any further adjustment. Fuses The circuitry of the amplifier is protected from damage by an automotive-type fast-blow fuse. If fuse replacement is necessary, use only fuses of the of the same ampere rating as originally supplied with the unit. The use of fuses with incorrect ratings may cause serious damage to the amplifier. If fuses blow consistently, carefully check all electrical connections to the unit. -8 90 DAY/12MONTH LIMITED WARRANTY 90 DAY/12MONTH LIMITED WARRANTY90 DAY/12MONTH LIMITED WARRANTY Applies to car stereo power amplifiers, equalizers and accessories. Applies to car stereo power amplifiers, equalizers and accessories.Applies to car stereo power amplifiers, equalizers and accessories. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workma...