Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
Or CATV Typical application diagram. 1001ST This unit allows any stereo Audio/Video source, to distribute Audio and Video to different locations over standard coax cable. The RF output can be changed to any channel between 14 to 69 or cable channels from 65 to 125 ( 95-99 not included). VIDEO Nominal Input level: Input Impedance: Isolation port to port: Isolation out to input: Video bandwidth: AUDIO Nominal Input level: Input impedance: THD: Frequency Response: Channel Separation: Signal to Noise: SPECIFICATIONS 1 Volt peak to peak 75 ohms 32 dB 60 dB > 4 Mhz 1 Volt peak to peak 22k ohm < 0.5% 20Hz to 14kHz >30dB >60dB @ 2 Volts POWER Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm Coaxial Center positive connector. Power Supply is included. WARRANTY Cable Electronics, Inc. warrants this product to be free from defects in material and workmanship, under normal use and service, for a period of one year from the purchase by the original purchaser. If this product is defective or malfunctions, Cable Electronics will replace or repair this unit (at their option) within a reasonable time. No expressed or implied warranty is made for any defects caused by immersion or exposure to liquids, abuse, neglect, improper operation of unit, excess wear and tear and defects resulting from unauthorized disassembly and or modification. NOTE: *Please allow one channel spacing above and below the modulator tuned channel to prevent interference to existing channels. *Press and hold the mode button to change the frequency output mode. Hold for at least 6 seconds or until display changes. 1001ST PERFORMANCE SPECIFICATIONS And Features Interface Tuning Display Mode Push button digital control 2 lA Digit, Seven Segment Digital Readout Selects Off-Air or Cable output frequencies Video Input Level: Standard 1 Vp-p Input Impedance: 75 ohms Connector: RCA Audio Full MTS Stereo Compatibility. Input level: Input Impedance: Frequency Response: Channel Separation: Signal to Noise: Distortion: Connector: Standard 1 Vp-p ( 2 Vp-p max ) 22K ohm minimum 20 Hz to 14 kHz Greater than 30 dB typical 60 dB Less than 0.5 % Two RCA, Right and Left Misc. Channel Range: RF Output Level: Power Supply: Size: UHF 14 to 69, Cable 65 to 94, 100 to 125 +20 dBmV, F connector 9 to 12 Vdc, 250 mA minimum 3.9 x 3.9 x 1.5 inches Internal Band Pass Filtering to virtually eliminate spurious signals Stereo encoder is Macrovision compatible for use with DVD and VCR sources...