Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
To cancel SOURCE DIRECT Press the SOURCE DIRECT key again. • The SOURCE DIRECT indicator goes out. Recording KAF-3030R/1030 (En) The figure shows an example for the KAF-3030R. : Keys or controls to be used in this operation. STEREO INTEGRATED AMPLIFER KAF-3030R PHONES ON OFF POWER STANDBY SPEAKERS A A+B BOFF L R BASS TREBLE BALANCE MIN MAX VOLUME CONTROL SOURCE DIRECT DIRECT TRAIT TAPE TUNER PHONO MD / CD-R Adv. DA / CD AUX Linear REMOTE CONTROL UNIT RC-A0301 4 . 7 6 4 . 7 3 8 ¦ 1 A 8 ¦ . . % % 1 A 27 3 A DISC SKIP B AUX TUNER TAPE POWER MD PHONO MUTE VOLUME CONTROL TUNER P.CALL CD TAPE MD Adv. DA/CD SOURCE DIRECT Adv. DA/CD DIRECT To record a music source One lights. TAPE Adv. DATUNER PHONO / CD MD / CD-R AUX • The indicator for the selected source lights. • When TAPE is selected with the INPUT SELECTOR, recording is possible with the MD recorder. • When MD is selected with the INPUT SELECTOR, recording is possible with the Tape deck. 1 Select the source to be recorded. 2 Put the cassette deck or MD recorder in record-pause mode. 3 Play the source and start recording. TAPE TUNER PHONO MD / CD-R Adv. DA / CD AUX INPUT SELECTOR To listen through headphones 1 Set of the SPEAKERS switches to OFF. 2 Plug headphones. 3 Adjust the volume. ..................................................................... To increase volume To decrease volume To decrease volume To increase volume Main unit PHONES MIN MAX VOLUME CONTROL Remote control unit (KAF-3030R only) . % VOLUME CONTROL SPEAKERS A A+B BOFF In case of difficulty KAF-3030R/1030 (En) What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or service representative. Operation to reset The microcomputer may fall into malfunction (impossibility to operate, erroneous display, etc.) when the power cord is un- plugged while power is ON or due to an external factor. In this case, execute the following procedure to reset the microcom- puter and return it to normal condition. Set the POWER to OFF then, while holding down the SOURCE DIRECT key, set the POWER switch to ON. •Please note that resetting the microcomputer clears the contents stored in it and returns it to the condition when it left the factory. Remote control unit (KAF-3030R only) Symptom Cause Remedy Remote control operation is not possible. • Batteries are exhausted. • The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle in between. • The audio cords and system control cords are not connected properly. • The source component to be operated does not contain the tape(s), CD or MD. • The POWER switch is set to OFF. • Replace with new batteries. ! • Operate the remote control unit within the controllable range. ! • Connect properly referring to “System connection”. 67 • Place the tape(s), CD or MD in the source component to be played. • Set the POWER switch to ON. @ Amplifier Symptom Cause Remedy Sound is not output. • The speaker cords are disconnected. • The VOLUME CONTROL is set to the minimum position. • MUTING is ON. • The SPEAKERS switches are set to OFF. • The system control cords are not fully connected. • Connect them properly referring to “System connection”. 8 • Adjust the volume to a proper level.@ • Press the MUTE key to OFF. # • Set the SPEAKERS switch(es) to ON. @ • Check the system control connections. 67 All indicators blink and sound is not output. • Speaker cords are short-circuited. • Turn the power off, eliminate the short-circuiting, then turn on the power again. Sound is not output from one of the speakers. • The speaker cord is disconnected. • The BALANCE control is set to an extreme position. • Connect it properly referring to “System connection”. 8 • Adjust the Left/Right balance. # No sound from a selected source. (KAF-3030R only) • Adv. DA / CD DIRECT is ON. (KAF-3030R only) • Press the Adv. DA / CD DIRECT key to OFF. (KAF-3030R only) Speaker protection circuit When this unit’s power is turned ON with the speaker cable short-circuited, the speaker protection functions. If the all indicators blink and no sound occurs, turn the power OFF, remove the short-circuit, then turn the power ON again. Notes The RDS EON function • When this unit is connected to a KENWOOD tuner with the RDS EON function using a system control cord, the input of this unit automatically switches to the tuner when the tuner receives a desired program in the EON reservation mode. • Note that the RDS EON function is not available while the Adv. DA / CD DIRECT is ON. NoteNote Do not use contact cleaners because they could cause a malfunction. Be specially careful of contact cleaners containing oil, for they may deform the plastic components. Caution: Read this page carefully to ensure safe operation. Specifications KAF-3030R/1030 (En) KAF-3030R Rated output power (DIN) 1 kHz at 8 W ............................
Otros modelos de este manual:El receptor y el amplificador - KAF-1030 (495.51 kb)