Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
to a wall outlet (mains). Now you can switch on the AV receiver, TV, subwoofer and other devices. . . Next, plug the supplied optimizer microphone into the AUTO CAL MIC jack. Place it roughly where you would normally sit, and at ear level – on Confirm active subwoofer setup. When a subwoofer is connected, turn it on and turn up the volume prior to activating it. Turn the subwoofer’s LEVEL dial up about 1/3 of the way. 4 4 the back of a sofa, for instance. 10 Put the batteries in the remote. Press ./.to turn the AV receiver on. “BD” appears in the front panel display. To ready the AV receiver for use, go through the on-screen [Easy Setup] using the supplied remote. This should only take a few minutes. If the setup screen is not displayed, select the correct AV input in your TV. Once [Easy Setup] is completed, select [Finish], and the AV receiver is ready to use. Put the batteries in the remote. Press ./.to turn the AV receiver on. “BD” appears in the front panel display. To ready the AV receiver for use, go through the on-screen [Easy Setup] using the supplied remote. This should only take a few minutes. If the setup screen is not displayed, select the correct AV input in your TV. Once [Easy Setup] is completed, select [Finish], and the AV receiver is ready to use. ./././., ./. 11 If an error code or warning appears on the TV screen after Auto Calibration, look it up below. After taking the appropriate steps, perform Auto Calibration again. Code 30 Headphones are connected to the PHONES jack on the receiver. Remove the headphones. Code 31 No speakers are selected. Press SPEAKERS to set the speakers. Code 32/Code 33 eeNone of the front speakers are connected, or only one front speaker is connected. eeThe optimizer microphone is not connected properly or the cable may be damaged. eeThe surround left or surround right speaker is not connected. eeSurround back speakers or front high speakers are connected even though surround speakers are not connected. Connect surround speaker(s) to the SPEAKERS SURROUND terminals. eeA single surround back speaker is connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B R terminals. When you connect only one surround back speaker, connect it to the SPEAKERS SURROUND BACK/BI-AMP/ FRONT HIGH/FRONT B L terminals. eeThe front high left or front high right speaker is not connected. Warning 40 The measurement process has completed with high noise level detection. Perform the measurement in a quiet environment. Warning 41/Warning 42 eeThe input from the optimizer microphone is too loud. eeThe distance between the speakers and the optimizer microphone is too close. Set them farther apart. Warning 43 The distance and position of a subwoofer cannot be detected. Perform the measurement in a quiet environment. 12 Now you can select any other equipment or devices you may have. 1 Press Input buttons to select the equipment you want. The available inputs are: Lastly, to enjoy multi-channel surround...