Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
When switched Into bridged mono mode, it shall deliver at least 550 watts into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 29dB ± ,5dB per channel and an input sensitivity of 1.3 Volts ± 2% for full rated output. Frequency response shall be 10Hz to 20kHz ± ,5dB. It shall be stable inio any load including pure capacitors and inductors. Hum and noise shall be at least 1 lOdB below full output and SMPTE intermodulation distortion shall be less than .01% at Tull output. The amplifier shall have rear panel switching for mono and bridging modes and rear mounted level controls. The inputs shall be balanced bridging type with male and female XI,R type connectors as well as I /4" phone jacks. A three-color LED type indicator shall be employed to show the power level of each channel and self contained forced air cooling shall be used. The power output derices shall be of the lateral MOS-FET type. The amplifier shall weigh 371b. net and mount in a standard 19 Inch rack tising two spaces (3.5" high). The power requirement shall be 110-125VAC, 50-6011/.. The power amplifier shall be an Ashly FET-1500M. Ashly Model 1500C The power amplifier, being of two channels, shall deliver a minimum power of 175 walls per channel into 8 ohm loads or 275 watts per channcl Into 4 ohm loads with both channels operating. When switched into bridged mono mode, it shall deliver at least 550 watts into an 8 ohm load. The amplifier shall be immune to damage from shorted, open, or mismatched loads. The amplifier shall have a gain of 29dB ± ,5dB per channel and an input sensitivity of 1.3 Volts ± 2% for full rated output. Frequency response shall be 101 Iz to 20kHz + ,5dB. It shall be stable into any load including pure capacitors and inductors. Hum and noise shall be at least HOdB below full output anti SMPTE intermodulation distortion shall be less than .01% at full output. The amplifier shall have rear panel switching for mono and bridging modes and rear mounted level controls. The inputs shall utilize 1/4” phone jacks as well as terminal/barrier input strips. Self contained forced air cooling shall be used. The power onlpui devices shall be of Ihe lateral MOS-FET type. The amplifier shall weigh 371b. net and motml in a standard 19 Inch rack using two spaces (3.5" high). The power requirement shall be 110-125VAC, 50-60HZ. The power amplifier shall be an Ashly FET-1500C. ASHL\ Since 1972 © 1989 Ashly Audio To provide maximum flexibility, Ashly offers two variations in our FET Power Amplifiers: The FET-1500M (top) features XLR and 1/4" inputs. The FET-1500C (bottom) utilizes Barrier Strips and 1/4" inputs....
Otros modelos de este manual:El receptor y el amplificador - FET-1500M (570.61 kb)