Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
The display panel returns to the original display and the setting is not changed. Checking the battery level You can check the amount of charge remaining in the battery loaded in AIBO. 1 Press the MODE button repeatedly until the battery level appears. The battery level is displayed in 4 steps. BAT Exhausted BAT o Low BAT oo Fairly low BAT ooo Fully charged Replacing the battery You can charge the battery loaded in AIBO by connecting the conversion plug and AC adapter. But you can also exchange the battery for one that has been charged with the Energy Station (separately available). 1 Press the pause button to pause AIBO. Wait until the chest light goes out. Chest light Note The battery pack lock indicator lights in red while AIBO is accessing the “Memory Stick”. To prevent damage to AIBO, do not remove the “Memory Stick” during this time. The battery is locked until the data-saving procedure is complete. Removing with force may damage AIBO. 57 Handling and settings 2 Grasp AIBO firmly by the body, turn it upside down, and then open the cover. Notes • Lift AIBO by the body, and not by the head, tail, or legs. • Do not touch the charging terminal with your hands. Doing so may soil the terminal and cause poor contact. 3 Slide the battery pack release lever and remove the battery. Hold your hand against the battery when you remove it. You can be injured by the battery if it falls Battery pack out suddenly. release lever Note The battery is locked when the battery pack lock indicator is lit in red. Removing with force at this time may damage AIBO. 4 Insert the charged battery until it clicks into place, then replace the cover. Attach the cover in Press here the direction shown 5 Place AIBO on the floor as shown below. Note 59 Handling and settings Be sure to place AIBO on the floor as shown above. This will prevent AIBO from moving unexpectedly and being damaged when you press the pause button to start AIBO. Installing the optional wireless PC Card Before installing the optional wireless PC Card, be sure to press AIBO’s pause button to make it pause. For more information about installing the PC Card, refer to the documentation supplied with the ERA-201D1 AIBO Wireless LAN Card. 1 Remove both of the left legs (see page 33 for details about how to remove them). The PC Card slot appears. 60 2 Firmly slide the PC Card all the way in. 3 Flip the PC Card release switch to the side. 61 Handling and settingsTo remove, flip the switch out. 4 Replace the left legs. World time zones Refer to this map when setting the time zone. 63 Handling and settings 64 Additional information This chapter provides notes on usage, a troubleshooting guide, and other information to help you get to know AIBO better. Notes on use To prevent AIBO and the AC adapter from being damaged, observe the following precautions. On handling AIBO • Do not use AIBO in places subject to vibrations, on an incline, or at a place where it might fall. • Do not press down hard on AIBO with your hand or elbow. • Do not drop or shake AIBO as this may damage AIBO or cause data saved to the “Memory Stick” to be lost. • Do not touch the charging terminal or a unit connector terminal with your hands. Doing so may soil the terminal and cause poor contact. • Lift AIBO by the body, and not by its head, tail or legs. Do not swing or twist AIBO. • Do not leave AIBO in very hot places, such as a car parked in the sun. • Do not allow foreign things, such as paper clips, to get into AIBO or its joints. • Do not use AIBO outdoors. If you do, moisture or other foreign matter may enter AIBO and cause damage. • Do not use AIBO on concrete or other hard surfaces as this may damage AIBO. • Do not allow AIBO to get wet. • Do not touch the lens of the color camera directly with your hand. • Do not apply stickers to the color camera. • Do not point the color camera at the sun, whether AIBO is turned on or off, as this may damage the camera. • Do not oil AIBO’s joints or other movable parts. • Do not apply stickers to AIBO’s movable parts or insert anything between them as this may interfere with AIBO’s movement. • Do not disassemble or modify AIBO. •When transporting AIBO, put it in a cushioned box like the one it came in to protect its body, head, tail and legs from damage. • Do not use AIBO in a place subject to strong electromagnetic waves or X rays. •The AIBO-ware applications designed for ERS-110/111 cannot be used with ERS-220. • ERS-220 cannot be used with “Memory Stick” applications that do not comply with OPEN-R Ver. 1.1. Moisture condensation If AIBO is brought directly from a cold place to a warm place, moisture may condense on AIBO’s inside or outside surfaces. Operating AIBO in this state can cause damage. If moisture condensation has occurred, wait for about one hour before turning AIBO on. 67 Additional information On handling the AC adapter • Be sure to use only the supplied AC adapter to charge AIBO’s battery. Using any other adapter may cause damage to AIBO. • Do n...