Department of Labor regulations GUARDE ESTAS INSTRUCCIONES! PAUTAS DE SEGURIDAD/DEFINICIONES Es importante para usted leer y entender este manual. La informacion que lo contiene relaciona a proteger SU SEGURIDAD y PREVENIR los PROBLEMAS. Los simbolos debajo de son utilizados para ayudarlo a reconocer esta informacion. Indica una situacion de inminente riesgo, la cual, si no es evitada, causara la muerte o lesiones serias. Indica una situacion potencialmente riesgosa, que si no es evitada, podria

6 PLANER PARTS 1 2 1 -12" Planer 2 -Chip Deflector Fig. 2 4 7 8 65 3 Fig. 3 3 -Knife Setting Gage 4 -8mm and 10mm Open-End Wrench 5 -M5 x 20mm Hex Socket Head Screw 6 -M5 Wing Nut (2) 7 -M5 Flat Washer (2) 8 -Elevating Handle 7 ASSEMBLY FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL. RAISING AND LOWERING HANDLE 1. Assemble raising and lowering handle (A) Fig. 4, to shaft (B) a

RAISING AND LOWERING HEAD ASSEMBLY The head assembly (A) Fig. 15, contains the cutterhead feed rolls, chip deflector and motor. Raising and lowering the head assembly controls the depth-of-cut on your planer. To raise or lower the head assembly, rotate the raising and lowering handle (B). NOTE: One revolution of the handle will move the cutterhead up or down approximately 5/64 . An English/metric scale (C) and pointer (D) is located on the side of the planer for ease in setting the height of the