Votos - 4, Puntuación media: 4 ( )

Fabricar: Delta Tamaño del archivo: 318.95 kb Nombre del archivo: Install_1243.pdf Idioma del manual:

Remove excess putty after installing drain on lavatory. 7 Secure lavatory to wall as shown in 5 or 5a. Install washers and hand tighten nuts or lag bolts. Level and square the unit. Connect hot and cold supply lines to the shut-off valves. Tighten trap joints for water-tight assembly. 8 Install pedestal screws. Securely tighten lavatory anchor nuts or lag bolts. alignment. It may be ne-cessary to cut off part of the tailpiece (area "B") and/or part of the drain elbow of the trap (area "C"). 3 Mark lavatory and pedestal screw locations mounting holes. If a steel hanger is supplied of its screws when positioned as shown 4 5 6 Approx. Bumper locations to raise the lavatory slab left side. Top of Pedestal 1-7/8" B C Shut-Off Valves Rear View Pedestal Screws Return the fitted lava-tory and pedestal to the installed position. Con-nect trap to drain assem-bly hand tight to check A ANCHOR SCREW INSTALLATION 5a Use lag bolts to secure lavatory as illustrated. LAG BOLT INSTALLATION Anchor Screw Washer Lavatory Nut Lag Bolt Washer Lavatory Lavatory Steel Hanger IMPORTANT: Final assembly of nut and washer or lag bolt method shown for reference only. (See steps 8 and 9). Place lavatory into installed position. and square the lavatory pedestal assembly. Use or more bumper cushions (supplied) to level and cushion lavatory slab to pedestal. For example only 9 Note: Space constraints may dictate method of fastening pedestal to floor. Remove lavatory and pedestal from installed position. Drill pilot holes for lavatory and pedestal anchor screws or lag bolts. Note: Some models are supplied with lag bolts, anchor screws, or steel hangers for lavatory installations only. Other models and all pedestals are not provided with mounting hardware. Various pedestal screw sizes and types are available to the installer at local hardware outlets. 2 Install lavatory anchor screws leaving 1-7/8" threaded end exposed as illustrated. Following manufacturer's instructions, install and drain assembly included). Be certain apply a bead of sealing on the underside of the (area "A") in order to ensure a watertight seal between the lavatory and drain. Remove excess putty after installing drain on lavatory. 7 Secure lavatory to wall as shown in 5 or 5a. Install washers and hand tighten nuts or lag bolts. Level and square the unit. Connect hot and cold supply lines to the shut-off valves. Tighten trap joints for water-tight assembly. 8 Install pedestal screws. Securely tighten lavatory anchor nuts or lag bolts. alignment. It may be ne-cessary to cut off part of the tailpiece (area "B") and/or part of the drain elbow of the trap (area "C"). 3 Mark lavatory and pedestal screw locations mounting holes. If a steel hanger is supplied of its screws when positioned as shown 4 5 6 Approx. Bumper locations to raise the lavatory slab left side. Top of Pedestal 1-7/8" B C Shut-Off Valves Rear View Pedestal Screws Return the fitted lava-tory and pedestal to the installed position. Con-nect trap to drain assem-bly hand tight to check A ANCHOR SCREW INSTALLATION 5a Use lag bolts to secure lavatory as illustrated. LAG B...

Descargar ahora

Introduzca dos números de la imagen: