Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
In Massachusetts, the maximum output temperature of the shower mixing valve can be no higher than 112.F. Recommended tools (not included) grease pencil or other marking tool level ruler 2 & 3 mm Allen wrenches 6 mm drill bit 8 mm wrench Philips screwdriver waterproof sealant ............................................................ 8 mm 2 mm 3 mm 6 mm Installation Drill the screw holes with a 6 mm bit. Install the anchors. If both ends of the showerpipe are mounted on tile, install the top and bottom mounting wall flanges. If the bottom of the showerpipe is mounted on tile, but the top is not, install the top wall flange with the tile matching disk. Push the shower arm and lower support into the ends of the riser. Install the escutcheons. Push the showerpipe assembly over the wall flanges. Tighten the set screws with a 3 mm Allen wrench. Install the showerhead on the shower arm. Use a level to make sure that the shower arm is straight. If it is not, loosen the mounting screws slightly with an 8 mm wrench. Reposition the arm until it is straight. Tighten the mounting screws. Attach the escutcheons to the flanges by rotating them clockwise. Tighten the shower arm safety screw with a 2 mm Allen wrench. Place a hose washer in one end of the hose. Connect this end to the water supply (not included). Place the screen washer in the other end of the hose. Connect this end to the handshower. Adjust the slider To make the slider easier to move up and down the bar, turn the screw counter-clockwise. To make it harder to move, turn the screw clockwise. This unit does not include a water supply. Use Hansgrohe model 27458XX3 or another supply that complies with ASME A112.18.1/ CSA B215.1 including ASME A112.18.3. harder easier User instructions When the water is turned on, it will come from the handshower. To use the showerhead, push the handshower up into the handshower holder on the bottom of the showerpipe. To remove the handshower from the showerpipe, push downwards on the holder (1), then pull the handshower down and out of the pipe(2). Approximately 1 quart of water will come from the bottom of the showerpipe when the handshower is removed. 1 2 Scale removal The showerhead and the handshower use the Quick Clean™ cleaning system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub across the channels with a finger or a sponge to dislodge them. To remove scale deposits from the showerhead spray face, pour about 3/4” of a commercial scale remover*, such as Lime-Away™ or CLR™, into a shallow dish. Soak the spray face for the amount of time shown in the label instructions. Rinse the showerhead with clear water. Install the showerhead. Flush it with clear water for at least one minute. 11 5 5 10 10 4 10x1,5 6 15x2,5 15x2,5 10x1,5 8 3 2 5 15x2,5 Replacement Parts 1 hose 28255000 2 slider 98714000 3 riser 96770000 4 escutcheon 98672000 5 wall flange 98673000 6 shower arm 98675000 7 screen washer 94246000 8 showerhead 98855001...
Otros modelos de este manual:Fontanería - Raindance Connect Showerpipe 27164001 (1.9 mb)
Fontanería - Raindance Connect Showerpipe 27164001 (1.9 mb)
Fontanería - Raindance Connect Showerpipe 27164001 (1.9 mb)