Votos - 2, Puntuación media: 3
(
)
)
|
Resumen del manual
Tighten the nut securely and make sure the pivot bar is free to rotate. NOTE: The pivot bar is designed to rotate 90 degrees from straight down to straight back. 5. With the pivot cranks straight down, insert them into the frame in the pockets where they were before step 2 above. Be sure they snap below the balls in the pockets. 6. Rotate the back end of the sander down so that the bracket on the sander fits over the rear pivot bar (make sure it snaps firmly) NOTE: It may be necessary to move the rear pivot bar into alignment with the bracket on the sander. Move the bar by rotating the adjustment knob on the rear of the frame, as shown in Figure 3. 7. The sanding frame is now properly installed. Adjust by rotating the adjustment knob. WOODWORKING TOOLS BY Form No. 74,430 Black & Decker (U.S.) Inc., U.S. Power Tools Group, 10 North Park Drive, P.O. Box 798, Hunt Valley, MD 21030-0798 U.S.A. 157 04 00 05...
Otros modelos de este manual:Máquinas de rectificar - 36070 (1.47 mb)
Máquinas de rectificar - 4024 (1.47 mb)