Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
Keep proper footing and balance at all times. 15. DISCONNECT TOOLS. When not in use; before servicing; when changing accessories such as blades, bits, cutters, etc. 16. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded surfaces such as pipes, radiators, ranges and refrigerator enclosures. 17. REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean at all times for best and safest performance. Follow instructions for lubricating and changing accessories. Keep handles dry, clean and free of oil or grease. Inspect switches, tool cords and extension cords periodically and have them repaired or replaced by an authorized service facility if damaged. Check moving parts for alignment and binding as well as for breakage and improper mounting. Damaged parts should be repaired or replaced by an authorized service facility unless otherwise indicated in this instruction book. CAUTION: Do not use carbon tetrachloride. 19. AVOID ACCIDENTAL STARTING. Don't carry a plugged-in tool with your finger on the switch. Be sure the switch is turned off before plugging in a tool. Do not use a tool if the switch does not turn it on or off. 20. WEAR EAR PROTECTORS when using for extended periods. 21. ACCESSORIES. The use of any accessories other than what is listed or recommended for this particular tool may be hazardous. 22. KEEP HANDS AWAY FROM CUTTING EDGES AND ALL MOVING PARTS. 23. USE INSULATED SURFACES. A double-insulated or grounded tool may be made live if the blade or bit comes in contact with live wiring in a wall, floor, ceiling, etc. Always check the work area for live wires and hold the tool by the insulated surfaces when making "blind" or plunge cuts. 24. GRINDING WHEELS. Use only grinding wheels with "Safe Speed" at least as high as the no load RPM" marked on the nameplate. 25. USE SIDE HANDLES when supplied with tool for control and safety. 26. STAY ALERT. Watch what you are doing and use common sense. Do not operate tool when you are tired. GROUNDING INSTRUCTIONS This tool should be grounded while in use to protect the operator from electric shock. The tool is equipped with an approved three-conductor cord and three-prong grounding-type plug to fit the proper grounding-type receptacle. The green conductor in the cord is the grounding wire. Never connect the green wire to a live terminal. If your unit is for use on less than 150 volts, it has a plug that looks like Fig. "A". If it is for use on 150 to 250 volts, it has a plug that looks like Fig. "C". An adapter. Fig. "B" is available for connecting Fig. "A" plugs to two-prong receptacles. The green grounding ear extending from the adapter must be connected to a permanent ground such as to properly grounded outlet box. No adapter is available for Fig. "C" plugs. COVER OF COVER OF GROUNDING EAR NOTE: RECEPTACLE MUST BE GROUNDED FOR SAFE USE OF ADAPTER; IF IN DOUBT CALL A QUALIFIED ELECTRICIAN AND HAVE THE RECEPTACLE CHECKED FOR GROUND. EXTENSION CORD CHART When an extension cord is used, it should be a 3 wire cord to permit proper grounding of the tool. As the distance from the supply outlet increases, heavier gauge extensions are required. The use of extension cords of ina...
Otros modelos de este manual:Máquinas de rectificar - 48-09-0300 (283.09 kb)
Máquinas de rectificar - 58-12-2331 (283.09 kb)
Máquinas de rectificar - 6012 (283.09 kb)