Votos - 1, Puntuación media: 5
(
)
)
|
Resumen del manual
NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. ATTENTION The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product. IMPORTANT: PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX. DANGER, Do not insert fingers near the shredder. DANGER, Do not wear dangling jewelry near the shredder. DANGER, Remove staples and paper clips before inserting page(s) into the shredder. DANGER, Do not insert disks, CDs or cassette tapes into the shredder. DANGER, Do not wear dangling ties near the unit. DANGER, Make sure your hair is not near the shredder. 1 MPS1500.O/M.QXD 8/12/02 11:34 AM Page 2 SAFETY PRECAUTIONS To guard against injury, the following basic safety precautions must be observed in the installation and use of this shredder. For your own safety, DO NOT ATTEMPT TO INSTALL OR OPERATE THE SHREDDER UNTIL YOU READ ALL THESE INSTRUCTIONS. • Make sure the power is off when the shredder is not used. • Do not use the shredder for anything other than its intended purpose (shredding paper documents). Do not shred cloth, plastic, cardboard, or any other hard material that will damage the shredder blades. Remove all paper clips and staples from paper before shredding. • Do not place hands or fingers into the shredder feed opening as serious injury may result. • Follow all warnings and instructions marked on the shredder. • This product should not be placed near, or over, a heat source. • Do not use this product near water or in areas of high humidity and avoid spilling liquids on it. • To stop shredding in case of emergency, slide the AUTO/OFF/REV switch to the OFF position and/or unplug the shredder immediately. For this reason, make sure the outlet that the shredder is connected to is easily accessible. • Do not leave the power cord where something may be placed on it, or it may be stepped on. • This unit should not be operated or stored near children or pets. • Always turn off or unplug the shredder prior to moving, cleaning or emptying the wastebasket. • The use of an extension cord is not recommended. PLEASE SAVE THESE INSTRUCTIONS TO GET THE MOST OUT OF YOUR SHREDDER: • Never try to shred more than the shred capacity. Overloading the shredder will shorten its durability. • Always feed the paper(s) in straight, do not feed at an angle. • Always use the shredder with the AUTO/OFF/REV switch in the AUTO position. • Clean the outside of the shredder by wiping it with a damp cloth from time to time. Mild stains can be removed using a soft, damp cloth and mild detergent. Remove detergent residue with a damp cloth. Always unplug the shredder before cleaning. • Never use any harsh or abrasive cleanser. • Keep the shredder away from direct sunlight. 2 MPS1500.O/M.QXD 8/12/02 11:34 AM Page 3 POWER SOURCE AC USAGE Use the AC polarized line cord included with the unit for operation on AC power. Insert the plug into a conveniently located AC outlet having 120V, 60 Hz. NOTE: The AC plug supplied with the unit is polarized to help minimize the ACPlugACOutlet possibility of electric shock. If the AC plug does not fit into a nonpolarized AC outlet, do not file or cut the wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet. LOCATION OF CONTROLS 1 23456 1. Shredder 2. BIN FULL Indicator 3. CLEAR Button 4. POWER Indicator 5. AUTO/OFF/REV Switch 6. Wastebasket 3 MPS1500.O/M.QXD 8/12/02 11:34 AM Page 4 OPERATION Follow the instructions below to operate your new shredder. After unpacking the shredder, place it securely on the supplied wastebasket. Then, plug the unit into an AC outlet as described on page 1. 1 2 Slide the AUTO/OFF/REV switch to Insert up to 5 pages of 20lb paper the AUTO position; the POWER into the shredder, and the unit will indicator will light. automatically shred them. NOTES: • If inserting small documents, insert them in the center of the shredder as the sensor is located there. • Do not attempt to insert more than 5 pages at a time, as it will shorten the life of the shredder. • The shredder will stop automatically if it is overheated by long and continuous intermittent operation. Allow the shredder to rest for approximately 20 minutes to cool down. WASTEBASKET FULL INDICATOR: When the wastebasket is full, the BIN FULL indicator will light on the cover. Empty wastebasket in this ...