Votos - 5, Puntuación media: 4
(
)
)
|
Resumen del manual
. . . . . . . . . . . . . . . . . . . Warranty . . . . . . . . . . . . . . . . . . . . . . Product Profile This product is built to shred paper, staples, small paper clips and credit cards. It is not built to shred adhesive labels, transparencies, newspaper, cardboard, large paper clips, or plastic (other than credit cards). Attempting to shred items not intended for this shredder may cause damage. Strip- cut Confetti- cut (120-2/C-120) (120C-2/C-120C) Paper Sheet capacity* 18-20 sheets 12-14 sheets Paper shred size 7/32" (5.8 mm) 5/32" x 1" (3.9 x 25 mm) Maximum paper width 9.5" (241 mm) 9.5" (241 mm) Recommended daily capacity 4,000 sheets 2,000 sheets Credit Cards Credit card capacity 1 1 Recommended daily capacity 10 10 * Based on 20 lb., 8-1/2" x 11" paper with shredder operating at rated voltage; heavier paper, high humidity, or other than rated voltage may reduce sheet capacity. IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING While setting up shredder • Check shredder for damage or defects; some paper particles in the basket due to product testing and does not indicate a defect. • Avoid touching exposed blades on underside of confetti- cut shredder head. • Plug power cord in an outlet that can easily be reached. The plug disconnect. • Make sure the electrical rating listed on the serial label (located of shredder) matches the available electric power. • Do not place shredder near or over a heat or water source. While operating shredder • Keep hands and hanging objects (jewelry, ties, loose clothing, long hair, etc.) away from paper entry. • Keep children and pets away from the shredder. When not in use • Always turn off and unplug shredder • Unplug before emptying basket • Do not open shredder head: Opening shredder head will NOTE: Do not use flammable aerosols of any kind Set-Up • Turn retractable feet (D) to outward position. This will improve stability. The feet should be turned outward if shredder will not be placed between furniture. • Pull waste basket drawer (A) completely out of cabinet. • Put waste bag in basket (sample bags provided). Allow edges to overhang. Contact Fellowes to order more bags. (Part #36054). • Slide waste basket drawer (A) into cabinet. The shredder will not operate if drawer is not pushed all the way into cabinet. • Plug power cord into a convenient outlet. Operation Control Switches E F G I H J Control Switch (E) Turbo Jam Release Button (G) Runs shredder when I AUTOMATIC button is held down. Turns on the automatic- start sensor and the green Ready light. O OFF Turns off the automatic- start sensor and the green Ready light. R REVERSE Runs shredder in reverse mode. Press and hold to activate. Troubleshooting Lights Ready Light (F) Basket Ajar (H) Basket Full (I) Paper Jam (J) (Green) Shredder is in auto- Waste basket drawer is Waste basket is full or Shredder is jammed matic start mode. open. paper has collected (e.g., too much paper under cutting cylin- fed at one time). ders. For convenience and energy savings, your shredder is equipped automatic- start sensor (K). This means that when the control switch (E) is in position, the shredder will start running when you after the paper has passed through. CAUTION: The automatic- start sensor cannot tell the difference between paper and other objects. This feature Always turn off the shredder when it is if it will not be used for an extended To shred • Press control switch (E) to automatic • Feed paper straight into entry Product Profile for limits on paper width, etc. 2 1 3 To empty waste basket If basket full light (I) is on, follow these steps until light turns off. • Press Turbo Jam Release Button (G) to finish shredding any paper in paper entry. – Press control switch (E) to the off [O] position. – Open the waste basket drawer (A) and remove full bag. – Place new bag in basket, then slide drawer into cabinet. • Press and hold control switch (E) in the reverse [R] position for a few seconds to clear paper shreds that have collected under cutting cylinders. – Alternate between manual forward (G) and reverse [R] for a few seconds in each position. CAUTION: The shredder may be damaged if you alternate too rapidly between forward and reverse. • Unplug shredder and remove wastebasket drawer (A). – Carefully clear any paper shreds that have collected on under side of paper entry (C). CAUTION: Models 120C-2/C-120C (confetti cut model) has exposed blades.Use care when removing paper shreds on underside of paper entry. To clear a paper jam If paper jam light (J) is on, follow these steps until light turns off. • Check the waste basket and empty if full. • Press and hold control switch (E) in the reverse [R] position to back paper out of paper entry (C). Try pulling gently on paper to remove it from shredder. • Alternate between forward and reverse, if needed: – Press and hold Turbo Jam Release Button (G) for a few seconds. – Press and hold control switch (E) in the reverse [R] position for a few seconds. – Contin...
Otros modelos de este manual:Trituradora, - 120C-2 (104.52 kb)