Votos - 4, Puntuación media: 5 ( )

Fabricar: Weed Eater Tamaño del archivo: 227.34 kb Nombre del archivo: Idioma del manual:

Pull up on the vacuum inlet cover with your other hand. Latch Area Impeller Locking Tabs REMOVE THE INLET RESTRICTOR (Some models) An inlet restrictor is used when operating your unit as a blower. This restrictor is not used during vacuum operation and must be removed during vacuum assembly. Once the cover is opened, look for the inlet restrictor between the door and the impeller. D Remove the inlet restrictor by rotating counterclockwise (see illustration). Keep this inlet restrictor for use when using your unit as a blower later. With the restrictor removed, the upper vacuum tube will twist onto the unit. ATTACH VACUUM TUBES S On some units an arrow on the tube and the unit will help you align the tube before twisting clockwise. S Some units may include locking tabs. These tabs guide and lock the tubes into position. Once the upper tube is secure on the unit, and cannot be turned clockwise further, the lower vacuum tube may be installed onto the upper tube. Arrow Arrow Lower tube Upper tube Not all unit will have arrows ATTACH VACUUM BAG Slide the vacuum bag over the blower outlet as shown. Secure the bag to the blower outlet by placing the strap through the metal ring. Pull tight and fasten as shown. Make sure the blower outlet is pushed far into the bag before tightening the strap. Some units may include elastic on bag without metal ring. Blower Outlet Vacuum Bag Strap Metal Ring D Carefully loop the shoulder strap through the buckle as shown. First In Last In D Position the unit on your right-hand side, blower outlet and bag pointing toward the rear. Hold the unit in an upright position, and support the lower vacuum tube on the ground. 6 D Place the shoulder strap over your head and onto your left shoulder. D Adjust the strap to allow a free flow of air from the blower. If the collection bag is kinked, the unit will not operate properly. NOTE: The strap is designed to position the collection bag on your shoulder without kinks. The strap is not intended to support the weight of the unit. SELECT AN EXTENSION CORD Use only a 120 A.C. voltage supply as shown on the nameplate of the unit. S To reduce the risk of electrical shock, this equipment has a polarized plug (one blade is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only oneway. If plug does not fit fully into the wall outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. The extension cord used to reach the power source must be: D Specifically marked as su...

Descargar ahora

Introduzca dos números de la imagen: