Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
- Models DS4600A-XXX0: This device is intended to be supplied by a UL Listed Direct Plug-in Power Unit marked “Class 2”, rated 10-30 V minimum, 0.60 A. This device may also be supplied by a UL Listed Power Unit marked “Class 2” or LPS power source which supplies power directly to the scanner via the 25-pin connector. - Model DS4600A-2XX5: This device is intended to be supplied by a UL Listed Direct Plug-in Power Unit marked “Class 2”, rated 24 V minimum, 0.50 A. This device may also be supplied by a UL Listed Power Unit marked “Class 2” or LPS power source which supplies power directly to the scanner via the 25-pin connector. WEEE Compliance: Laser Safety: The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a Class II laser product according to CDRH regulations. For installation, use and maintenance it is not necessary to open the device. There is a safety device which allows the laser to be switched on only if the motor is rotating above the threshold for its correct scanning speed. The laser beam can be switched off through a software command (see also the WinHost Help On-Line). AVOID EXPOSURE LASER LIGHT IS EMITTED FROM THIS APERTURE CAUTION-CLASS 3B LASER LIGHT WHEN OPEN AVOID EXPOSURE TO BEAM DATALOGIC S.p.A. Via Candini, 2 40012 LIPPO DI CALDERARA (BO) ITALY Model No. Serial No. Volt Amp. Manufactured This product conforms to the applicable requirements of 21CFR1040 at the date of manufacture. LASER LIGHT DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT MAXIMUM OUTPUT RADIATION 1 mW EMITTED WAVE LENGTH 630~680 nm TO EN 60825-1 (2001) Warning and device class labels The laser diode used in this device is classified as a class 3B laser product according to EN 60825-1 regulations and as a Class IIIb laser product according to CDRH regulations. As it is not possible to apply a classification label on the laser diode used in this device, the following label is reproduced below. LASER LIGHT AVOID EXPOSURE TO BEAM CLASS 3B LASER PRODUCT MAX. OUTPUT RADIATION 30 mW EMITTED WAVE LENGTH 630~680 nm TO EN 60825-1 (2001) Laser diode class label Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode (30 mW at 630 to 680 nm). DS4600A QUICK GUIDE DS4600A -X X X X Decoding Mode Reading Range Optic Version Special Features 2 = Standard w/ Display 3 = Advanced Code Reconstruction 0 = Medium Range 1 = Long Range 2 = Short Range 0 = Linear 1 = Raster R1 2 = Raster R2 0 = Standard 5 = Integrated Heater The following table displays each version’s reading performance. Version Reading Distance Max Code Resolution mm (mils) Speedscans/s 210X 200 mm (8 in) - 980 mm (39 in) on 1.00 mm (40 mils) codes 0.50 (20) 800 200X 160 mm (6 in) - 540 mm (21 in) on 0.50 mm (20 mils) codes 0.25 (10) 800 220X 50 mm (1.97 in) - 400 mm (15.75 in) on 0.80 mm (31 mils) codes 0.20 (8) 800 310X 200 mm (8 in) - 970 mm (38 in) on 1.00 mm (40 mils) codes 0.50 (20) 800 300X 160 mm (6 in) - 540 mm (21 in) on 0.50 mm (20 mils) codes 0.25 (10) 800 320X 120 mm (4.7 in) - 310 mm (12.2 in) on 0.30 mm (12 mils) codes 0.20 (8) 800 Technical Features: ELECTRICAL FEATURES SOFTWARE FEATURES Power Supply Model XXX0: 10 –30 Vdc Model 2XX5: 24 Vdc Readable Codes EAN/UPC (including Add-on 2 and Add-on 5) Code 39 2/5 Interleaved Code 128 EAN 128 Code 93 Codabar Pharmacode Power Consumption max. Model XXX0: 6W Model 2XX5: 12W Main Serial Interface RS232; RS485 Full-Duplex RS485 Half-Duplex Auxiliary Interface RS232 Baudrates 1200 to 115200 Inputs External Trigger, IN1, IN2 (optocoupled NPN or PNP) Headers and Terminators Up to four header and four terminator characters Voltage max. 30 Vdc Operating Modes On-Line, Automatic, Serial-On-Line, Test Current Consumption max. 25 mA Configuration Modes Through menus using WinHost utility Host Mode (commands from one of the serial ports) Outputs OUT1, OUT2 (optocoupled OE or OC) VCE max. 40 Vdc Code Selection Up to six different codes during one reading phase Collector Current max. 40 mA continuous; 130 mA pulsed Parameter Storage Non-volatile internal EEPROMVCE Saturation 1V at 10 mA max. Power Dissipation max. 90 mW at 40 °C (Ambient temp.) ENVIRONMENTAL FEATURES Operating Temperature 0° to 40 °C (32° to 104 °F) 2XX5: -30° (-22 °F) to 40 °C OPTICAL FEATURES Light Source Semiconductor laser diode Storage Temperature -20° to 70 °C (-4° to 158 °F) Wavelength 630 to 680 nm Safety Class Class 2 - EN 60825-1; CDRH Humidity max 90% non condensing USER INTERFACE Vibration Resistance IEC 68-2-6 test FC 14 mm @ 2 to 10 Hz 1.5 mm @ 13 to 55 Hz 2 g @ 70 to 200 Hz 2 hours on each axis LED Indicators Ready, Good Read, External Trigger, Data TX PHYSICAL FEATURES Shock Resistance IEC 68-2-27 test EA 30g; 11 ms; 3 shocks on each axis Dimensions 101x84x42 mm (4x3.3x1.7 in) Weight 615 g. (22 oz) Protection Class IP65 DS4600A QUICK GUIDE Name Description Part Number C-BOX 100/200 Connection Box 93ACC1510, 93ACC1520 C-BOX 300/310 Connection Box Profibus ...
Otros modelos de este manual:escáner / copiadora / impresora multifunción - Laser Barcode Reader DS4600A-2XX5 (1.05 mb)