Votos - 6, Puntuación media: 3.3
(
)
)
|
Resumen del manual
It can then be taken to the sink and washed using warm soapy water, gently wipe the cooking surface with a dishcloth. DO NOT use abrasive cleaning materials. REPLACEMENT OF OVEN LIGHT BULB CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK Light bulbs are not covered by the manufacturer’s guarantee. A new 15W, 300°C rated SES bulb can be obtained from your cooker supplier or any major electrical retailer. 1. Remove the shelves from the oven. 2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely event of a lens fracture. 3. Unscrew bulb. 4. Fit new bulb and refit lens. CARE AND CLEANING COOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate (Traditional), pan supports, burner caps, roasting dish, grill pan, oven base, rear and roof, door inner panels, grill and warming compartments. Cloth wrung out in warm soapy water. Stubborn stains can be removed with a cream paste, liquid cleaner or by rubbing with fine steel wool soap pads e.g. Brillo, Ajax. Check that the cleaning agent is approved by the Vitreous Enamel Association. Aluminium Burner bodies, door handles. Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from the hotplate burner ports. Care should be taken when refitting the bodies over the electrodes. Glass As for enamel cleaning. Polish with a clean dry cloth or kitchen roll. Chromium Plating Oven shelves, grill pan grid, grill pan handle support Wipe with a cloth wrung out in warm soapy water. A fine steel wool soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner may be used. Plastic Grill pan handle, control knobs, door handle supports. Wipe with a cloth wrung out in warm soapy water. Stainless Steel (Professional) Door trims, control panel, hotplate. Wipe with a cloth wrung out in warm soapy water. Polish with a clean dry cloth or kitchen towel. For stubborn stains, use a proprietary stainless steel cleaner and follow the instructions on the container. Paint Control panel and doors (Traditional), side panels Wipe with a cloth wrung out in warm soapy water only. DO NOT USE ABRASIVES. SOMETHING WRONG WITH YOUR COOKER Before contacting your Service Centre or Installer, check the problem guide below, there may be nothing wrong with your cooker. PROBLEM CHECK Slight odour or small amount of smoke when grill/oven used for first time. This is normal and should cease after a short period. Oven cooks too fast or too slow. Check that the oven setting and shelf positions are as recommended in the Cooking Charts. However, it may be necessary to increase or decrease the recommended setting slightly to suit your taste. Ignition does not work. If all burners fail to ignite: Check that sparks appear at the burners; a clicking noise should be heard. If not (i) Check that the electricity supply is turned on. (ii) Check other appliances to see if you have had a power cut. If only one burner fails to ignite: (i) Check the burner cap is seated correctly. (ii) Check the slots in the burner bodies are not blocked with any soap residue or cooking soil (see care and cleaning). (iii) Check, if the burners have recently been cleaned using a wire wool pad eg. “Brillo Pad’, ensure that no stray strands are caught on the ignitor or burner body. NOTE. Satisfactory ignition will only be achieved if all the hotplate burners are fitted. In the event of an electricity failure, all burners can be lit with a match. SOMETHING WRONG WITH YOUR COOKER PROBLEM Cannot set an ‘Auto Cook’ programme or cannot get the Timer to turn the oven on or off at the required times. Timer display shows ‘0:00’ with ‘AUTO’ flashing. Fanned oven does not work, but the grill, top oven and hotplate burners work. Oven lamp does not work. Read the Timer instructions in this book carefully remembering that the Cook period is the length of time that the timer will switch the oven(s) on as part of an Auto Cooking Programme. The electricity supply to the cooker may have been interrupted, but has now come back on again. Set the correct time of day by following the instructions given in the Timer section of this book. The Timer may be set for an Auto Cooking programme. Check the Timer to see if “AUTO” is illuminated. If it is, follow the instructions given in the Timer section of this book to cancel the Auto Cooking programme. The oven lamp is not covered by the guarantee. The part is easily changed (see the section on oven lamp replacement). A new lamp may be obtained from our Parts Department (see Key Contacts, back page). CHECK If there is still a problem contact your local Service office (see KEY CONTACTS, back page). INSTALLATION INSTRUCTIONS Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge which is fitted on the rear ...
Otros modelos de este manual:ollas a presión - 10456G (286.61 kb)
ollas a presión - 10455G (286.61 kb)
ollas a presión - 10450G (286.61 kb)
ollas a presión - Traditional 1000 (286.61 kb)