Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
The oven lamp is not covered by the guarantee. The part is easily changed (see the section on oven lamp replacement). A new lamp may be obtained from our Spare Parts department, see Key Contacts (back page). CHECK The timer may be set for an Auto Cooking Programme. Check the timer to see if “AUTO” is illuminated. If it is, follow the instructions given in the timer section of this book to cancel the Auto Cooking Programme. This is normal and should cease after a short period. Check that the gas mark and shelf positions are as recommended in the Oven Cooking Charts. However, it may be necessary to increase or decrease the recommended setting slightly to suit your taste. The electricity supply to the cooker may have been been interrupted, but has now come back on again. set the correct time of day by following the instructions given in the timer section of this book. INSTALLATION INSTRUCTIONS Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge which is fitted on the back panel. This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. particular attention should be given to the relevant requirements regarding ventilation. MODEL NUMBERS GW54, GW62, GW66, 6DOG Category I2H (GB. IE) These models are set to burn NATURAL GAS (G20) at 20 mbar ONLY and can not be used on any other gas. MODEL NUMBER GW54L, GW62L, GW66L Category I3+ (GB. IE) These models are set to burn PROPANE GAS (G31) at 37 mbar and BUTANE GAS (G30) at 28-30 mbar GAS SAFETY (INSTALLATION & USE) REGULATIONS It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law. In the UK, CORGI registered installers work to safe standards of practice. The cooker must also be installed in accordance with BS 6172. Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution. LOCATION The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bed-sitting room of less than 20m3. LPG Models shall not be installed in a room or internal space below ground level, e.g. in a basement. PROVISION FOR VENTILATION The room containing the cooker should have an air supply in accordance with BS 5440: Part 2. The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the room has a volume between 5 and 10m3, it will require an air vent of 50cm2 effective area unless it has a door which opens directly to outside. If the room has a volume of less than 5m3, it will require an air vent of 100cm2 effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted to determine air vent requirements. INSTALLATION INSTRUCTIONS TECHNICAL DATA DIMENSIONS Height 900 - 915mm Width 600mm Depth 595mm (excluding door handles) GENERAL Gas connection Rp 1/2 (1/2” BSP female) Pressure test point Grill injector Gas rate adjustment None Aeration adjustment None Electrical connection Flexible cord fitted with a 3 pin 13 amp plug 230/240V a.c. 50Hz. 3A fuse. NATURAL GAS MODELS LPG MODELS BURNER HEAT INPUT INJECTOR HEAT INPUT INJECTOR HOTPLATE Front left and rear right 3.0 kW 128 2.8 kW (205g/h) 82 HOTPLATE Front right and rear left 1.9 kW 102 1.8 kW (130g/h) 65 GRILL 3.8 kW 135 3.3 kW (235g/h) 91 MAIN OVEN 2.7 kW 120 2.4 kW (175g/h) 75 TOP OVEN 2.0 kW 100 2.0 kW (145g/h) 60 INSTALLATION INSTRUCTIONS SPACE FOR FIXING The cooker can be close fitted below hotplate level. This requires a minimum distance of 600mm between cupboard units of hotplate height. When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above hotplate level, allow a side clearance of at least 65mm. The diagram below illustrates the minimum clearance between the cooker and adjacent walls, cupboards etc. The wall behind the cooker, 50mm below and 450mm above, and the width of the cooker, must be a non-combustible material such as ceramic wall tiles. If the cooker is to be fitted close to a corner on the left hand side, ensure that there is a clearance of at least 50mm to allow the main oven door to open fully for when removing oven shelves. 65 mm Min400 mm Min750mm min 600 mm Min COOKER HOODS If a cooker hood is to be installed, refer to the cooker hood manufacturers’ instructions regarding fixing height. 125mm INSTALLATION INSTRUCTIONS UNPACKING THE COOKER Unpack the components from inside the grill and oven: Check that the following parts are present. Grill pan and grid Top oven/grill shelf heat shield Pan suppor...
Otros modelos de este manual:ollas a presión - GW54 (413.26 kb)