Votos - 4, Puntuación media: 4.5 ( )

Fabricar: Craftsman Tamaño del archivo: 1.74 mb Nombre del archivo: Idioma del manual:

Allow the engine to cool before storing in any enclosure. • Always refer to the Operator’s Manual for important details if snowthrower is to be stored for an extended period. • Run auger drive a few seconds after completion of throwing snow to help clear out snow and prevent icing and freeze-up on unit. 3 4 SAFETY DECALS Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the operator of the most important safety precautions. All warning, caution and instructional messages on your snowthrower should be carefully read and obeyed. If any of these decals are lost or damaged, replace them at once. They can be purchased from your local dealer. DANGER AVOID INJURY FROM ROTATING BLOWER! Shut off engine before unclogging discharge chute. 1716533 Part No. 1716533 Discharge Chute Danger Decal Part No. 1716669 Main Dash Decal (Electric Start Models) Safety Rules & Information DANGER AVOID INJURY FROM ROTATING AUGER! Keep hands, feet, and clothing away. 1716532 Part No. 1716532 Auger Danger Decal Part No. 1716670 Main Dash Decal (Manual Start Models) Part No. 1716672 Auger Control Decal Part No. 1716671 Warning Decal International Symbols FAST SLOW STOP CHOKE PRIMER ELECTRIC START IGNITION KEY RUN 5 Assembling the Snowthrower TOOLS REQUIRED • Socket or Wrench Set • Pair of Pliers ASSEMBLY PROCEDURE If your unit was not previously assembled, see Figures 1 and 2, and follow the steps below to assemble the unit: 1. Install the discharge chute on to the rotating ring located on the auger housing. Secure with the three 5/16 inch carriage bolts, flat washers and nylok nuts found in the parts bag (the bolt heads go to inside of of the rotating ring, with washers and nuts on the outside). Note, install the rear bolt first for easier alignment. 2. Tighten bolts securely with a wrench. 3. Lift up folding handle to align it with lower handle and tighten the wing knobs securely as shown in Figure 3. The snow thrower is now ready for operation once the fuel tank has been filled with the properly mixed gasoline and two cycle oil. Figure 1. Assembly of Discharge Chute A. Discharge Chute D. Nuts B. Carriage Bolts E. Rotating Ring C. Washers A B C D E Figure 2. Handles A. Handle B. Wing Knobs A B Figure 3. Lift Handles and Lock Wing Knobs 6 Controls & Operation Auger Control Chute Direction Control Chute Deflector A B C Engages auger when pulled back, and disengages auger when released. Rotates discharge chute to desired direction Controls vertical angle snow is thrown. Figure 4. Snowthrower Controls A B C SNOWTHROWER CONTROLS Auger Control A. Auger Control - This control engages and disengages the auger. Pull the control back against handle to engage the auger, (this will pull snowthrower forward if auger is in contact with the ground). Release the Auger Control to stop rotation of auger. Deflector Controls B. Chute Direction Control - The Chute Direction Control (B, Figure 4) allows the discharge chute to be rotated to throw...

Descargar ahora

Introduzca dos números de la imagen: