Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
In the standby mode, press the left soft key and then press the * key within two seconds to lock the keypad. Do the same to unlock it. And – don’t worry – you can answer an incoming call normally even when the keypad is locked. 20 what the icons mean Signal strength New SMS / text, message. (The text box is full when it blinks.) Keypad locked Silent Battery status Sound on / normal status Alarm clock set Headset Outdoor Meeting Missed call Call diverting 21 installing the battery 1. Lift up the battery cover up from the little notch on the bottom of the back cover and remove. 2. Insert the battery by aligning the gold-coloured contacts with the contacts in the battery slot. 3. Push the battery down into place. 4. Replace the battery cover and close it gently until you hear a click. Remove the battery cover Push down the battery 22 Replace the battery cover removing the battery 1. Make sure your phone is switched off. 2. Remove the battery cover. 3. Pull the battery up and out. 23 Remove the battery cover Pull up the battery from here inserting your SIM The SIM (Subscriber Identity Module) is a microchip that holds your personal information, such as names and phone numbers. Your phone won’t work without it. If you already have contacts on your SIM, they can usually be transferred. 1. Make sure your phone is switched off and the charger is disconnected. 2. Turn the phone over and remove the battery cover. 3. Slide the SIM into the slot as shown below with the gold contacts facing downwards. 24 4. Replace the battery. 5. Replace the back cover. To remove the SIM, simply reverse the process. 25 inserting a memory card You can use a memory card to expand the storage of your phone – storing or copying files such as photos, music, etc. Do not remove the card or switch off the phone while transmitting or saving data, because it may cause data loss and damage the phone or the card. Insert the memory card as follows: 1. Open the battery cover and remove the battery. 2. Follow the OPEN arrow to slide back the metal card holder, and flip it up. 3. Insert the card into the metal slot with the metal contacts facing downward until it clicks to the right position. 4. Following the direction of the LOCK arrow, click the card holder back into place. 26 Slide the metal card holder Flip up the metal card holder Insert the memory card Flip the card holder back and lock it charging the battery Your phone is powered by a lithium ion rechargeable battery. To give it a long and healthy life, use it straight from the pack without charging. Then exhaust it completely and then recharge it completely… at least three 27 times. Your new battery’s top performance is achieved only after three complete charge and discharge cycles. 1. Connect the charger cable to the phone as shown in the diagram below. 2. Plug it into a mains socket. 3. The battery charging indicator will appear on the screen. 4. When the indicator shows the battery is fully charged, disconnect the c...