Votos - 1, Puntuación media: 5
(
)
)
|
Resumen del manual
If in doubt, use the next heavier gauge. Remember, the smaller the gauge number, the heavier the cord. Volts Total Length of Cord in Feet 120V 25 50 100 150 AWG 12-16 Amps 14 12 Not Recommended 5 230 Volt Operation If 230V, single-phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the power source. 2. This lathe is supplied with four motor leads that are connected for 115V operation, as shown in Figure A. Reconnect these four motor leads for 230V operation, as shown in Figure B. 3. The 115V attachment plug (A), supplied with the lathe, must be replaced with a UL/CSA listed plug suitable for 230V operation (D). Contact your local Authorized Service Center or qualified electrician for proper procedures to install the plug. The lathe must comply with all local and national codes after the 230-volt plug is installed. 4. The lathe with a 230 volt plug should only be connected to an outlet having the same configuration (D). No adapter is available or should be used with the 230-volt plug. Important: In all cases (115 or 230 volts), make certain the receptacle in question is properly grounded. If you are not sure, have a registered electrician check the receptacle. Introduction This manual is provided by JET covering the safe operation and maintenance procedures for a Model JWL-1442VS Wood Lathe. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance to instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site: Table of Contents Warranty.................................................................................................................................................. 2 Warnings................................................................................................................................................. 3 Grounding Instructions............................................................................................................................. 5 115V Operation ....................................................................................................................................... 5 230V Operation ....................................................................................................................................... 6 Introduction ............................................................................................................................................. 7 Table of Contents..................................................................................................................................... 7 Specifications .......................................................................................................................................... 8 Contents of the Shipping Container.......................................................................................................... 9 Unpacking and Cleanup........................................................................................................................... 9 Assembly ................................................................................................................................................ 9 Stand Legs (optional accessory) ............................................................................................................ 10 Stand Shelf............................................................................................................................................ 10 Controls and Features ........................................................................................................................... 10 Lathe Tools............................................................................................................................................ 12 Mounting Workpiece Between Centers .................................................................................................. 13 Stock Selection...................................................................................................................................... 14 Roughing Out ........................................................................................................................................ 14 Beads, Coves, “V” Cuts and Parting....................................................................................................... 15 Sanding and Finishing ........................................................................................................................... 16 Face Plate or Bowl Turning......................................................................................................