Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
Press the button again to restart the programme. Cancelling a programme Turn the selector dial to to cancel a programme which is running. You can select now a new programme. Opening the door After the programme has started (or during the delay time) the door is locked, if you need to open it, set first the machine to PAUSE by pressing the button 8 . If the door cannot be opened, this means that the machine is already heating or that the water level is too high. Do not try to force the door! During drying phase the door can be opened only the first 10 minutes and at the end of drying (after Anti-Crease phase). If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to O . After a few minutes the door can be opened (pay attention to the water level and temperature!) . After closing the door, it is necessary to select the programme and options again and to press button 8 . At the end of the programme The machine stops automatically. Three blinking 0.00 appear on the display and the Use - Drying Drying only Warning! The recommended load size is 4 kg for cottons and linen, and 3 kg for synthetic items. By pressing Drying Time button it is also possible to dry up to 6 kg of cotton items (see the «Drying Programme » table). Warning! pilot light of button 8 goes off. Some acoustic signals sound for a few minutes. If a programme or an option that ends with water left in the tub has been selected, the door remains locked to indicate that the water must be emptied out before opening the door. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to O . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 8 . At the end of the programme, turn the programme selector dial to O to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand By : If your laundry is not removed within 10 minutes after the programme is finished, the back light of the display switches off and the energy saving system will be enabled. Only the pilot light of the button 8 is blinking to indicate that the appliance has to be switched off. By pressing any button the appliance will come out from the energy saving status and you can set another programme or switch the appliance off. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. 1. Load the laundry. 2. Select a spin cycle at the maximum spin speed allowed for the type of laundry in order to obtain the best drying performances. 3. Select the drying programme for Cottons or Synthetic in the Drying sector of the programme selector dial. 4. If you wish to select an electronic drying, depress the button 4 until the icon corresponding to the required dryness degree 12 electrolux appears on the display, marked with the icon . 5. If you wish to select a timed drying, press button 5 until the time you want appears on the display (see the «Drying Programme » table). Every time you press this button the drying time increases by 5 minutes. Note! The programme time will automatically increase by some minutes. 6. Press button 8 to start the programme. After the programme has started, the time remaining is updated every minute. Note! The different type of cottons (towelling, sheets, shirts, and so on) or any laundry items rolling up during the spinning phase may result in partial dryness. In the exceptional case that at the end of the cycle the laundry remains slightly wet, we suggest that you unfold the rolled up items, redistribute them evenly in the drum and select an additional drying cycle of 20-30 minutes. 7. At the end of the programme, the buzzer sounds and three blinking « 0.00 » appear on the display and the door is locked. The last 10 minutes of the drying cycle correspond to an anti-crease phase. During this time the door is locked and the display keeps showing three flashing zeros « 0.00 ». If you wish to open the door before or during the anti-crease phase or to interrupt it, press any button or turn the programme selector dial to any programme position (except O ). 8. Turn the selector dial to the O position to switch the machine off. 9. Remove the laundry. Automatic washing and drying (NONSTOP programme) For NON-STOP programmes, the recommended load size is 4 kg for cotton and 3 kg for synthetic. Helpful hints and tips It is possible to dry up to 6 kg of cotton items by pressing Drying Time button only (see the «Drying Programme » table). Caution! Do not use a dosing device/ ball when carrying out a washing and drying programme. 1. Load the laundry. 2. Add detergent and fabric softener. 3. Switch the machine on by turning the selector dial to the selected washing pro- gramme/f...