Votos - 4, Puntuación media: 4
(
)
)
|
Resumen del manual
• Electric models can exhaust 4 ways, from the right or left side, rear or bottom. Gas models can exhaust 3 ways, from the right side, rear or bottom. Both gas and electric models are shipped for rear exhaust. • The dryer must be connected to an individual branch circuit protected by the required time delay fuses or circuit breakers. 208V or 240V installation requires 30 amps. (Gas dryers require 120V, 60Hz, 15 or 20 amp circuit.) Locate the receptacle where it will be accessible when the dryer is installed. Power cord length is 36". • Follow the installation instructions packed with the product to complete the installation. Note: Do not discard shipping bolts, clips or any parts removed during installation. The consumer should keep unused parts for possible future use or shipping. Washer Clearances: • Allow 1-1/2" from the back of the washer to rear wall for drain hose and standpipe. 0" to both sides. Dryer Clearances: • 0" to either side, 3" rear, 3" clearance at the front, when installed into a recess or closet. When installed in a closet allow a min. of 120 sq. inches of opening such as louvers on the door. • For complete installation instructions refer to washer Pub. No. 31-2819 and dryer Pub. No. 49-9963. • Top caps on the washer and dryer must be removed and replaced with a top sheet kit. The addition of a standard 1-1/2" thick countertop over the pair will result Washer Top Sheet Dryer Top Sheet Countertop A B C 3/4" High x 3/4" Wide Lip on All Sides DIMENSION A: 14" recommended, however this laundry pair can be elevated to suit customer needs. • All four sides of the platform should be permanently secured and extend a minimum of 3/4" above the platform. • Height is only limited by the use of overhead cabinetry. • The standpipe height must be increased to accommodate additional installation height. DIMENSION B: • The platform must be constructed to include a 3/4" high and 3/4" wide lip all the way around the top edge. The outside depth should be 29" minimum. Consideration should be given to the location of the washer standpipe and dryer duct run. DIMENSION C: • The outside width should be wide enough to accommodate the laundry pair, plus a 3/4" lip on each side. Recommend 56" to 60" width. • The platform surface must be constructed to minimum code floor requirements. • The structure must be secured to a rear wall. • To complete the installation follow instructions packed with the washer and dryer. • Order Built-In Instructions, Pub. No. 14-T029 • No trim kits required. in a standard 36" countertop height. • Install the washer and dryer according to the installation instructions packed with the products. Built-In Under Counter Create an efficient work space for folding and storage. • Install an extra deep countertop to accommodate the laundry pair. Adjacent cabinets can be moved forward to align with the front face of the washer and dryer. • Order Accessory Kits: Washer Pub. No. 14-A037 Dryer Pub. No. 14-A008 Elevate the pair for easy acce...
Otros modelos de este manual:Lavadoras - 14-A008 (1.11 mb)
Lavadoras - 14-T029 (1.11 mb)