Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
,, = optional Operating Instructions When the Programme has Ended Spin/End indicator light flashes. ,, ,, ,, ,, Turn the programme selector to Off . If required: Select an additional programme (Spin or Rinse). ,, ,,,, ,, Start/Pause button. At the end of the programme option, turn the programme selector to Off. Unloading the laundry Turn off the water tap. Open the loading door. If the loading door can not be opened: Wait for 2 minutes ( the safety function is active ). Unload the laundry. Caution: Remove any debris (e.g. Coins, paper clips ) from the drum and rubber seal---risk of rust formation! Leave the loading door open to allow the inside the wash -ing machine to dry out. Press the 19 Operating Instructions Cleaning and Care Risk of electric shock! Always disconnect the appliance from the mains before cleaning. Never clean the washing machine with a jet of water. Risk of explosion! Never use solvents to clean the appliance. Cleaning the appliance housing and control panel As required: Use hot soapy water or a mild, non-abrasive cleaning agent. Rub dry with a soft towel. Cleaning the drum In the event that rust spots have formed due to leftover debris (e.g. Coins, paper clips, needles, nails): Use a chorine-free cleaning agent. Follow the manufactur , -er s instructions. Never use steel wool. Operating Instructions Clean the detergent dispenser In the event that residual detergents or additives have accumulated. Pull out the detergent dispenser up to the end stop. Press down the hollow on the insert and remove the detergent dispenser completely. Pull up the insert. Rinse the detergent dispenser under hot running water. Push down the insert until it clicks into place. Insert the detergent dispenser. Clean the drain pump This is necessary if the washing solution can not be complete -ly drained. The pump is blocked by either loose debris or fluff which accumulates if fluff-giving fabrics are washed at high temperature. Draining the washing solution The water in the drum should be drained first before cleaning the drain pump. Have a suitable container ready. Risk of Scalding Allow the hot washing solution to cool. ,, Off ,, . Turn the programme selector to Fold FoldFold down downdown the thethe cover covercover panel. panel.panel. (WFD50810) 21 2. 1. Operating Instructions (WFD50818) (WFD50810) (WFD50818) Carefully remove the pump cap. But do not fully remove it and allow a little more residual water flow into the suitable container. Remove the pump cap. Remove any loose debris/fluff from inside the pump and clean the pump. The pump impeller must be able to rotate. Clean any residual suds or fluff from the thread of the pump cap and pump housing. Attach and tighten the pump cap. Attach and close the cover plate. To avoid unused detergent from flowing into the drain during the next wash cycle: Pour 1 litre of water into chamber II ,, ,, Select the Spin programme. Cleaning water inlet strainers This necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hose: Turn of the water tap. Turn the programme selector to any programme. ,, (Except Spin ) Press the Start/Pause ,, ,, ,, button, and allow the programme to run for approx.40 seconds. Operating Instructions Cleaning the strainer at the water tap Disconnect the hose from the water tap. Rinse the strainer under flowing water. Reconnect the hose. Cleaning the strainer on the washing machine Disconnect the hose from the back of the washing machine. Pull out the stainer and rinse under running water. Insert the strainer and reconnect the hose. Turn on the water tap and check whether water is still discharged. If water is still discharged, check that the strainer is attached properly. Turn off the water tap. Descaling the washing machine Caution: Descaling agents contain acids which can attack parts of the washing machine and discolour the laundry. Provided that you use the correct amount of detergent, it is not necessary to descale the washing machine. If, however, descaling the appliance becomes necessary, please follow the instructions provided by the descaling agent manufacturer. Frost protection If the machine is located in a room which is exposed to freezing temperatures, any residual water in both the pump and the water inlet hose must be drained immediately every time the machine is used. Draining the pump: ,, ,, See Cleaning the pump on page 20. Draining the water inlet hose: 1. Turn the tap OFF. 2. Unscrew the hose from the tap and hold the end of the hose over a container. 3. Switch ON any of the washing programmes for approximately 40 seconds. Water left inside the inlet hose will be drained out. 4. Screw the hose back onto the tap. Operating Instructions Trouble Shooting Minor Faults 23 Risk of electric shock Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault youself with the aid the f...
Otros modelos de este manual:Lavadoras - WFD50818 (1.33 mb)