Votos - 3, Puntuación media: 4.3 ( )

Fabricar: Maytag Tamaño del archivo: 46.11 kb Nombre del archivo: Idioma del manual:

11 wire from the signal lamp assembly. Unsnap and discard the ON Light lamp assembly. 4. Fold the Black No. 3 wire back and tape the wire to the main harness out of the way. 5. Locate and remove connector P7 from the left side of the Machine Control board. 6. insert the jumper wire (Red Wine No. 3), found in the service repair assembly, into position number 5 of the P7 connector, then reconnect the P7 connector back onto the Machine Control Board. 7. Remove the Yellow based indicator lamp found in the service assembly and position the lamp where the previous ON Light lamp assembly was previously removed. Then snap the new lamp assembly into the console. 8. Connect the White No. 11 wire and the Red No. 3 wire to the new yellow based lamp assembly. 9. Remove the existing electrical schematic taped to the rear wall of the console and replace with the electrical schematic found in the service assembly. 10. Reposition the console into the upright position on the topcover and secure the three screws fastening the console to the rear console cover plate. 11. Replacement is complete. 1...

Descargar ahora

Introduzca dos números de la imagen: