Votos - 3, Puntuación media: 3.7 ( )

Fabricar: Samsung Tamaño del archivo: 941.06 kb Nombre del archivo: Idioma del manual:

2. Rotate the filter counterclockwise and pull out the filter. 3. Remove dirts and rotate the filter clockwise until it locks in position. Remark : Should be cleaned Filter at least 1 time a week. Filter Close Rag Open CONNECTING THE DRAIN HOSE Insert the drain hose(a) and push it tighly to be connected as arrow direction. (WITHOUT PUMP) Install the drain hose about 70~80cm above the ground for pump model. 70~80cm OVERFLOW FILTER Pull the upper side of the overflow filter with two fingers into the hole ‘A’ in the direction of arrow as shown in the figure. Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. 3 WT80J7-02206A_EN.indd 3 2006-02-17 .AEA 2:43:19 4 WASHING PROCEDURE TO WASH 1. Before starting washing, check the following; - Connect the water supply hose and open the water tap. - Connect the power cord to the power supply outlet. - Lay the drain hose(A) down toward a sinkhole. - Place the drain hose(A) in sink or bath about 70~80cm above the ground. 2. Set the WASH SELECTOR KNOB to the desired mode. 3. Set the CYCLE SELECTOR KNOB to ‘WASH·RINSE’. (In case no drain pump) (‘WASH’ in case drain pump) 4. Set the WATER SELECTOR KNOB to WASH . 5. Load laundry in the wash tub. 6. Fill water in the wash tub and add the detergent. 7. Set the WASH TIMER 1-15 minutes. 8. After washing,set the CYCLE SELECTOR KNOB to ‘DRAIN’ for drain. SPIN DRY 1. Transfer the clothes into the spin basket and arrange the clothes evenly. 2. Be sure to attach the safety cover and close the inner lid. 3. Close the spin dryer lid. 4. Set the AIR TURBO SPIN TIMER 1-10 minutes. 5. Incomplete spining. (Severe vibration or unbalance) See “When you load ...”on page 6. inner lid safety cover (Without pump) (With pump) (WITHOUT PUMP) (WITH PUMP) 70~80cm Bottom of balancer Safety cover WT80J7-02206A_EN.indd 4 2006-02-17 .AEA 2:43:22 5 RINSING 1. Set the CYCLE SELECTOR KNOB to ‘WASH RINSE’. (In case no drain pump) (‘WASH’ in case drain pump) 2. Supply the proper amount of water as not to overflow the top of the washing tub. 3. Set the WASH TIMER 2~3minutes. 4. Drain the water. Set the CYCLE SELECTOR KNOB to ‘DRAIN’ 5. Repeat this cycle until drain water is clean. (2~3 cycles) 6. In case no drain pump. - Be sure lay the drain hose down. In case drain pump. - Be sure place the drain hose in sink or bath. OVER FLOW RINSE 1. Keep suppling water Adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. 2. Set the WASH TIMER 6~8 minutes. 3. As soon as the WASH TIMER shuts off, turn off the water tap. 4. Set the CYCLE SELECTOR KNOB to ‘DRAIN’. ADDITIONAL RINSE After rinsing you can select this course for more effective rinse (Don’t select only this course for rinse.) 1 Load the laundry evenly into the spin basket. 4 After stopping water supply, cover the laundry with safety cover and close the in...

Descargar ahora

Introduzca dos números de la imagen: