Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
** Gentle Spin: Gentle reduced spin cycle at 100 rpm. *** Rinse Stop: Laundry remains in the last rinse water. RINSE STOP (Spulstop) For delicate textiles and curtains. The laundry remains in the final rinse water. . The laundry goes through a short intermediate spin cycle during the ”Delicates”, ”Woollens” and ”Silk” programmes. . The ”Spinning” and ”Pause” display bars flash alternately. - the machine should be emptied and the laundry spun. Using pushbutton 7 , choose one of the spin speeds appropriate for the type of laundry. The Remaining Time is indicated in the display panel. At the end of the programme, a Stop appears in the display. -the machine is to be drained. Select Gentle Spin/100 using pushbutton 7 . The laundry is gently spun dry. The Remaining Time is indicated on the display panel. A B C D Note:The laundry may be removed if ”Stop” is displayed. The drum lids are facing up. You may open the lids and remove the laundry. 27 Safety features Lid opening safeguards: After the programme starts, the appliance lid is locked. After the programme ends or during RINSE STOP, the lid is unlocked. Depending upon the model, if a DELAYED START or ENDING TIME was programmed, then the lid remains unlocked during the entire waiting period before the start of the programme. If the lid is to be opened during the programme, quickly push the ”Start/Pause” pushbutton and wait approximately 1 to 2 minutes until the lid safety unlocks. In order to avoid scalding, the lid remains locked until the wash water has cooled down somewhat. Water safety During operation, the constant water level control prevents possible overflows. Safety during spinning The washing machine is equipped with a safety feature that can reduce the spin speed if imbalanced loading occurs. In this case, the laundry may be insufficiently spun dry. Evenly distribute the laundry in the drum and select a new spin cycle. Protection against foaming over Too much foam may be produced in your washing machine during spinning. In this case, the spinning is stopped and the machine is drained. The programme continues. The spin speed is adjusted and an additional rinse cycle is performed. Before switching on the machine, check that the mains lead is connected and the tap is open. Ensure that all lids are properly closed. For purposes of safety, it is recommended that the mains cable be unplugged and the tap closed when the programme has ended. After a power outage, the programme resumes from the point at which it was broken off. PROGRAMME FOR STANDARD AND COMPARISON TESTS Programme ..............................................................................................................COTTONS 60°C Load ................................................................................................................................................5 kg Programme setting for testing in accordance with or following EN 60 456 and IEC 60 456. 28 Cleaning and Care Risk of electrical shock! Completely disconnect the washing machine from the mains. Never clean the washing machine with a jet of water. Explosion hazard! Never use solvents for cleaning. Danger of freezing! When there is danger of freezing, remove the water inlet hose and completely drain the washing machine. In this way, excess water that could still be in the dispenser will be drained out. Cabinet Use only soap and water. Control panel, base, etc. Use only a moist towel. Do not use: • Scouring powder • Metal pads or plastic sponges • Alcohol-based products (alcohol, diluents, etc.) Interior components It is recommended: • to leave the lid open for some time after washing. • to clean the plastic and rubber parts of the washtub inlet about once a month with soapy water. Rinse thoroughly to remove all traces of this cleaning material. • it is suggested that the 90°C washing programme be run at regular intervals. Detergent compartment Clean the detergent dispenser regularly. For this purpose: - To remove the detergent dispenser, squeeze both pressure points simultaneously (Figure 10). The dispenser then detaches itself from the compartment (Figure 10). - Remove parts . at the rear of dispenser . and separate from front cover . (Figure 11). - Rinse the parts under running water. Completely empty the dispenser. - Reassemble all components in the proper order. Snap the detergent compartment into place under the lid of the washing machine. Figure 10 Figure 11 JH I 29 Cleaning the Filter • Gently turn the drum with the open lids to If the pump filter is not regularly front side of the machine (Figure 14). cleaned, then this may adversely affect the performance of the machine. Cleaning the pump filter This filter collects bits of fluff and small objects, e.g. detached buttons that have fallen into the container. To clean, proceed as follows: • Open the drum lids. On the floor of the drum, there is a laundry agitator . (Figure 12). Figure 14 B • Remove pump filter from its holder (Figure 14). • Remove forei...
Otros modelos de este manual:Lavadoras - WOT24550EE/03 (801.77 kb)
Lavadoras - WOT24550EE/05 (801.77 kb)