Fabricar: Alliance Laundry Systems
Tamaño del archivo: 6.64 mb
Nombre del archivo: c1c98792-56a6-4d2e-ae87-b70abcd2c25c.pdf
|
Resumen del manual
Loading the dryer when it is running shall be avoided to prevent the clothes overdried or incompletely dried. Please flip clothes over manually from time to time, if necessary, when drying large ones. It is not easy to flip over large clothes (such as overcoat) in the drum, uneven drying therefore happens sometimes. If necessary, flip them over manually from time to time to make them dried completely. Operation Cautions Put rumpled clothes in order Put all clothes in order after dehydrated before drying them. Remove the clothes out of your dryer as early as possible to reduce rumples. Please hang the easily crumpled clothes up with a hanger after dried Anti-wrinkle method for clothes crumpled easily Decrease capacity to get good antiwrinkle result (the capacity shall be 4/5 of that of normal clothes). Avoid to dry starched clothes in your dryer to prevent link filter from clogging, which may lead to bad exhaust performance. Flip over clothes Capacity reduced Installation Instructions For your safety and correct using your dryer, please observe all the instructionsin this manual toinstall and adjust your dryer. Location of your dryer Dryer should be located in a dry and well-vented place, not filled with moisture andvapors and where rain cannot reach (like bathroom,open balcony and water faucet). Do not locate your dryer in a place where sunlight directly shines. Do not use stove, gas etc. near your dryer to avoid dangers. Locate your dryer on horizontal solid ground, floor or a special bracket to prevent vibration and noise. Keep a dista nce of 10cm-15cm away from the rear wall when installing. The dryer has air intake and exhaust cycles,which needs good air-exhaust vent in the rear and well-vented room. If used in a small space, air exchange fan or exhaust duct can be installed at the vent to exhaust hot wet air outdoors. The length of exhaust duct shall not exceed 2m. 10-15cm10-15cm Install and use the fixed legs of your dryer Soft items LegIf the dryer is not used with bracket, take fixed legs out of the accessory bag and screw them into the assembly hole of the dryer to ensure it be placed stable. 6 F 7 8 9 Using Method 1. Plug the power cord The appliance shall be supplied with220- 240V,50Hz, connected to a special receptacle more than 10A (reliably grounded). 2. Place the dehydrated clothes in your dryer Check the following items before putting clothes in. They shall be loaded in such a way that 2-3 pieces each time and not in a group to avoid tangling, which is not easy to turn it over resulting in uneven drying since the clothes were wrapped. Before drying your clothes Make sure if clothes have any special requirements and suitable for drying. Do not dry your clothes in your dryer if the materials of which cannot be dried in a dryer or they bear the following labels: Carefully check the clothes to be dried and remove combustible material such as lighter and match as well as sharp metal items like coin, hair clip and safety pin maybe mixed...
Otros modelos de este manual:Secadoras - GDZ5.0-61 (6.64 mb)
Secadoras - GDZ3.5-61 (6.64 mb)
Secadoras - GDZ3.5-61 (6.64 mb)
Secadoras - GDZ3.5-61 (6.64 mb)