Votos - 6, Puntuación media: 4
(
)
)
|
Resumen del manual
3. After a period of time, a gleam due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush. Remove the filter from the door pulling it out. (It can be positioned with the locating spur facing to the left or to the right). After cleaning do not forget to put it back. 4. Push down the unlock button on the large mesh filter. The large mesh filter pops up. 5. Take out fine filter. 17 6. Remove the fluff from fine filter. It is best to use a damp hand for this purpose. Clean the entire filter area The filter area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. 7. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. 8. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. 9. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. 10. Re-insert fine filter. 11. Press against the large mesh filter until it locks into the interlock. If the fine filter is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the water reservoir Empty the water reservoir after every drying cycle. If the water reservoir is full, an active programme will break off automatically and the warning lamp Full tank lights. In order to continue the programme, the water reservoir must first be emptied. 18 Warning! The condensed water is not suitable for drinking or for preparing foodstuffs. 1. Take out drawer containing water reservoir completely 1 and pull up the water reservoir's drainage pipe as far as it will go 2. 1. 2. 2. Pour the condensed water out into a basin or similar receptacle. 3. Slide the outlet connections in and refit the water reservoir. If the programme has been interrupted as a result of the water reservoir being full: Press the Start/Pause button to continue the drying cycle. The water reservoir has a volume of approx. 4 litres. The condensed water can be used as distilled water, e.g. for steam ironing. However it must first be filtered (e.g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger filters If the warning lamp Condenser lights, the heat exchanger fluff filters in the base of the appliance must be cleaned, i.e. after each 3 drying cycles. Both filters are located in the appliance base. Water can collect in the filter housing therefore it is normal for the heat exchanger fluff filters to become wet. Important! • Never operate the dryer without the fluff filters. • Clogged filters cause higher energy consumption (drying cycle elongation) and dryer damage. • A dirty heat pump can only be cleaned up by means of a costly process. 19 1. Open door in plinth: To do this, press the release button on the right and open the door in the plinth to the left. 2. Pull the filter housing out of the base by the handle. 1 1 2 4. Use a damp hand to remove the fluff from the filter in the base . If necessary pull out and clean the filter with warm 2. Pull the filter housing out of the base by the handle. 1 1 2 4. Use a damp hand to remove the fluff from the filter in the base . If necessary pull out and clean the filter with warm 3. To clean the fluff filter: Remove filter water using a wiper or brush. Clean the from filter housing. To do this, press the pressure points on the sides and pull the filter frame up and out of the housing. inside of the door, the fluff filter chamber and the rubber seals of fluff. Insert the fluff filter to the base. Remove fluff from the fluff filter with a 5. Insert the fluff filter into the filter damp hand. housing (it has to audibly lock) and slide it inside the filter chamber. Close the door in plinth. Note: If the fluff filter is not inserted in the filter housing, the filter housing cannot slide into the appliance base. 20 6. When necessary, approx. once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. When doing this, please use rubber gloves. Tip: The fluff can be removed more easily if it is first dampened (e. g. with a laundry dampener) or with help of vacuum cleaner. Cleaning the drum Caution! Do not use abrasives or steel wool to clean the drum. What to do if ... Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. Use a standard domestic cleaner (e.g. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe d...