Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Tie strings and sashes to prevent snagging and tangling. • If possible, turn pockets inside out for even drying. • Check for stains which may not have been removed in washing. Dryer heat may permanently set some stains. Repeat stain removal process before drying. • Place small items in a mesh bag to prevent tangling and for easy removal. 2. Check that lint screen is clean and in place. 3. Load the dryer. • The average load will fill the drum 1/3 to 1/2 full. Items need room to tumble freely for even drying and less wrinkling. Do not overload dryer. • When drying large items, dry only 2 or 3 at a time. Fill out the load with small and medium sized items. • For delicate or very small loads, add 2 lint-free towels for better drying, less wrinkling, and to prevent grease stains caused by fabric softener sheets. • Do not overdry items. Overdrying can cause wrinkling, shrinkage, harshness, and a build-up of static electricity, which can produce more lint. • If desired, add a dryer fabric softener sheet. 4. Close the dryer door and set dryer controls (some models). See Operating Instructions card for your specific model controls. 5. Turn cycle selector clockwise to the desired setting. 6. Start the dryer. • Push Start button for 2 seconds. • To add or remove items when the dryer is running, open the door. The dryer will always stop when the door is opened. Allow the drum to come to a complete stop before reaching inside. • To restart dryer, close the door, then push the START button for 2 seconds. • The dryer will not start if the cycle selector is in the OFF position. 7. When the cycle ends, remove items immediately and hang or fold. If load is removed before the cycle ends, turn cycle selector to OFF. Cycle Signal Control (some models) When the Cycle Signal Control is ON, a signal will sound at the end of each cycle and during the Press Saver setting (some models). The volume is adjustable on some models. Drum Light (some models) A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light. Reversible Dryer Door Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. Refer to the INSTALLATION INSTRUCTIONS for directions on changing the door. Drying Rack (some models) Use the drying rack to dry items which should not be tumble dried. 1. Open the dryer door and remove the lint screen. 2. Insert drying rack into the dryer drum. Place the front bar under the lip of the lint screen opening. 3. Place items to be dried on top of the rack. Weight should not exceed 10 lbs. Leave space between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack. 4. Select a timed dry setting best suited for items being dried. Use only the Air Fluff (no heat) temperature setting for items containing plastic, foam rubber, rubber-like materials, feathers or down. 5. When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause damage to the dryer. Drying Procedures Follow fabric care label instructions. Fill dryer drum 1/3 to 1/2 full. Place small items in a mesh bag. Features Place the front bar under the lip of the lint screen opening. Care and Cleaning Clean lint screen after every load. Do not store or place laundry products on top of dryer at any time. They can damage the finish or controls. To reduce risk of fire or serious injury to persons or property, comply with the basic warnings listed in Important Safety Instructions, pages 2-3, and those listed below. • Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards. • Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur. Inside • Clean the lint screen after every load. Lint build-up in the screen restricts air flow, which causes longer drying times. The screen is located at the bottom of the door opening. Remove by pulling straight up. Remove the lint and replace the screen. • Occasionally a waxy build-up may form on the lint screen from using dryer-added fabric softener sheets. To remove this build-up, wash the lint screen in warm, soapy water. Dry thoroughly and replace. Do not operate the dryer without the lint screen in place. • If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser. Remove cleanser residue before drying the next load. • Every 18 months an authorized servicer should clean the dryer cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard. Outside • Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers. • If the cabinet becomes stained, clean...