Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
In both washing and drying, the bulk or volume of clothes, rather than pounds, will determine the load size. The Amana dryer cylinder is large and is designed to dry a large or average load at maximum efficiency. DO NOT OVERLOAD THE DRYER - Maximum load = dryer cylinder one half full of wet clothes. Loads consisting of several small pieces only, such as knit shorts or diapers, do not tumble well, may require longer drying and could wrinkle excessively. Add several towels to aid tumbling. Large and small items together make the best load for the dryer. For the most even drying, fabrics in a load should be of similar weight. If mixed loads are dried, remove the lighter weight fabrics when they are dry. Avoid overdrying to prevent harshness of fabrics, wrinkling and possible shrinkage. Remove cotton sheets slightly damp, and fold and smooth by hand for less wrinkling. PERMANENT PRESS AND SYNTHETICS These loads will require some special treatment to get the best results from their “no-iron" properties. Static electricity may cause garments of synthetic fibers (as in lingerie) to cling together especially if they are overdried. The use of a liquid fabric softener in the rinse water of the washer will soften clothes and reduce static electricity. As an alternative, fabric softener sheets may be used in the dryer. Do not wash or dry clothes that shed lint in the same load with permanent press or knit garments. Remove permanent press load immediately after dryer stops. If the permanent press load is wrinkled, add a wet towel and operate the dryer for an additional 10 minutes with heat and cool down, remove load immediately. LINT FILTER The lint filter is located at the front of the dryer in the lower part of the door opening. See illustration below. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. A clean lint filter insures efficient drying. The filter can be taken out to remove lint. TO REMOVE LINT: Wipe across the filter with damp fingers. TO REMOVE LINT FILTER: Lift filter up and out of door opening. See illustration below. Filter may be washed if any residue is noticed on it. TO REPLACE FILTER: Place filter in door recess and push in firmly. Be sure to replace the filter with the words FRONT facing the front of the dryer. CAUTION - THE LINT FILTER MUST BE IN PLACE IN THE DOOR OPENING WHEN USING DRYER OR LOADING AND UNLOADING DRYER. If the filter is not in place, clothing could fall into the front air duct and get into the exhaust system and cause damage to the motor. EXHAUST SYSTEM We recommend the dryer be exhausted to the outside atmosphere to assure maximum drying efficiency. The exhaust duct should be cleaned periodically to remove any obstructions. Check occasionally to make sure the flapper on the outside weather hood moves freely, is not pushed in and that nothing has been shoved against it. Check too that the flapper is not standing open. -9-...
Otros modelos de este manual:Secadoras - LE1100 (989.41 kb)
Secadoras - LED250 (989.41 kb)
Secadoras - LGD251 (989.41 kb)