Votos - 1, Puntuación media: 5 ( )

Fabricar: Premier Mounts Tamaño del archivo: 298.88 kb Nombre del archivo: Idioma del manual:

See figure 1. NOTE: The plenum base pan width of 52.750” is such that it will fit directly inside the first and forth 16.000” center wood stud in a standard framed wall if applicable in the location selection. INW60 Series Prior to cutting, survey the wall that is to receive the plenum base pan to ensure the area to be cut into is free of obstructions such as cables, wire pipes etc. The base pan requires a wood frame or other suitable material to support a weight of at least 300 lbs. with a width opening of 64.250” minimum and a height opening of 44.750” minimum and a wood stud depth of 3.50” minimum. See figure 1. NOTE: The plenum base pan width of 64.00” is such that it will fit directly inside the first and forth 16.000” center wood stud in a standard framed wall if applicable in the location selection. Figure 1 Wood stud frame Wood studs Wall structure - 5 - 6 - Step 2 Partial “knock outs” are incorporated in the top and upper back on both sides of the base pan for bringing power and signal cables into the pan in accordance with code. Insert the pan fully (in the case of a standard 2 x 4-stud wall) or to the desired depth in a deeper wall structure. Secure the pan to the wood stud frame using nails or wood screws (commercially available). See figure 2. NOTE: A standard “handy box” extension ring can mount directly to the inside of the pan at the knock out points to provide an A/C power duplex outlet mounting point. Step 3 Install the muffin fan to the mounting bracket (refer to the muffin fan manual for air flow position). Secure the muffin fan with the four (4) 6/32” hex nuts and Phillips screws (supplied) See figure 3. Mounting studs for the fan bracket Cable access hole Nails or wood screws Wood stud frame Plenum (4) 6/32” Hex nuts Muffin fan Muffin fan mounting bracket (4) 6/32”x 2” Phillips screws Figure 2 Figure 3 - 7 - Step 5 Install the mount to the rear of the display with the mounting hardware supplied. Lift the display and mount assembly (minimum two people recommended) and secure to the base pan by allowing the mount tabs to be inserted fully into and down the receiving slots on the back of the plenum. See figure 5. Decorate the front of the Plenum per customer request. Step 4 Install the ventilation assist fan (if used) on one of the three 10/32” thread mounting points in the top of the base pan with the three 10/32” nuts supplied. The fan supplied uses 110-volts A/C current and comes with “pig tail” ends. It is recommended the fan be wired to the same 110-volt A/C switch leg as the feeding power to the display. This will insure the operation during all times when the display is on. Install all power and signal interface cables. See figure 4. Plenum Muffin fan (3) 10/32” Hex nuts Figure 4 Figure 5 Wall structure Receiving tabs on the plenum Mounting bracket Plenum Caution: All four (4) tabs must be fully inserted to the receiving tabs before letting go of the display. Muffin fan bracket studs Disp lay ...

Descargar ahora

Introduzca dos números de la imagen: