Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
3 Do not repeatedly press the buttons on the remote control. Allow interval of no less than one second between selections. The buttons marked with shades don't function for the TV set. STANDBY Channel Number VOLUME DOWN RECALL CCD/TEXT CHANNEL SCAN VOLUME UP INDICATOR CHANNEL UP TIME SETTING STEREO MUTE MENU SELECT 8 PF Series Instruction Manual INTRODUCTION (continued) Menus Press the MENU button , and the TV will display the primary menu as follows: Menu Picture Audio Tuner Timer System To adjust a function, press the / buttons to highlight the selection, and press the / buttons to select a sub-menu. (Take English menus for example). Picture Audio Tuner Tint 00 2 Bass 31 Channel Brightness 32 Add Treble 31 Add/Erase 32 Balance Contrast Ai r 00 Antenna Surround Low Auto Program Color 32 AVC Off Stop Start Sharp 32 MTS Mono Timer System Time Language Blue Back On Eng. Fra. Esp. On Time CCD/Text Off Cn Channel Parental Guide On Off Time MPAA- R TV - Y7 After selecting a sub- menu, press the / buttons to highlight the desired item and press the / buttons to adjust. MENU display except “ Tuner” disappears 6 seconds after last selection. Notes: 2 3 1 After calling up the sub menu, pressing the MENU button can return to the primary menu dispIay. The adjustabIe Tint range in the Picture menu and BaIance range in the Audio menu are - 31 ~ +31 and L31 ~ R31 respectiveIy whiIe the other adjustments are 0 ~63. When the Tuner menu is recalled, the display will not disappear automatically. Press the DISPLAY button to cancel menu display. CaII up a sub - menu in the same way mentioned above, then press the / buttons to highlight an adjustment and the / buttons to adjust the seIection. ln the foIIowing function introductions, the operations are simiIar to the above ways unIess otherwise noted. 9 PF Series Instruction Manual INSTALLATION Please read the safety instructions in this manual completely before installation. Install your TV in a room where direct sunlight will not fall upon the screen. Allow enough space (at least 10cm) between the TV and the wall for proper ventilation. It is recommended to watch TV in soft and indirect light. The optimum watching distance is 5-7 times of the screen's vertical length. Auto-degaussing Color TV is easily affected by magnetism which leads to color distortion. If your TV is moved or affected by near magnetic components or appliances with power on, turn it off for 1 hour. The built-in auto-degaussing circuit will eliminate the magnetism interference. To Connect the Antenna An outdoor antenna or CATV is recommended for the best reception. 75-ohm coaxial cable 300-ohm twin-lead cable OR OR Antenna adapter (not supplied) U/V mixer (not supplied) Notes: 1 It is recommended that a 75 coaxial cable be used in order to eliminate possible interference and noise which may occur due to nearby radio transmissions. 2 The antenna cable should not be tied together with other wiring. 3 Set up a lightning arrester and check it regularly when an outdoor antenna is used. 1.Remove the battery compartment lid. 2.Place in two AAA batteries. Make sure the positive + and negative -polarities are correct. 3.Reattach the battery lid. Notes: 1 Alkaline batteries are recommended for longer life. Always replace both batteries with fresh ones of the same type. 2 Do not expose batteries to fire or disassemble them. 3 To avoid battery leakage, remove batteries from the remote control when it is not to be used for a long period of time Remote Batteries VHF UFH or Cable VHF UHF or the batteries are exhausted. 10 PF Series Instruction Manual INSTALLATION (continued) To Connect External Equipment The following are optional connections. Please refer to operation manuals of external audio/video equipment that will be connected to your set. Connect VCR' s or DVD player' s RF OUT terminal to the ANTENNA IN jack located on the rear panel. Coaxial Cable ANTENNA IN VCR with Modulator YCbCr AUDIO/VIDEO OUT AUDIO DVD Player With S-VIDEO Terminal Camcorder VIDEO AV IN Yellow Yellow White AUDIO White Red Red VCR Front-set AV IN(4) MONITOR OUT VIDEO AUDIO/VIDEO IN Yellow Yellow White White AUDIO Red Red VCR Notes: 1 Before connection, do power off your TV and external equipment. 2 To receive signaIs from externaI equipment, you must seIect a proper AV input. 3 Do not use S - VIDEO and AV IN(1) terminals at the same time. 11 PF Series Instruction Manual BASIC FUNCTIONS Power On/Off 1. Power on 1) When in the Power On mode, press the button on the remote controI to enter the Standby mode. At this time, the power indicator lights. (Part of circuit on the TV set remains active when the TV in the Standby mode. ) 2) In the Standby mode, pressing any of the , CH - / + buttons on the remote controI can enter the Power On mode. 3) When in the Power On or Standby mode, press the MAIN POWER SWlTCH button to power off the TV. Note: Avoid switching the TV on and off frequently. Doing so may shorten life span of internal components. Auto off...
Otros modelos de este manual:TV - PF3225 (733.79 kb)
TV - PF2725 (733.79 kb)