|
Fotos y especificaciones Sony KV-XR29M80 |
Otros manuales para este modelo:
Resumen del manual
Your TV can receive either 525i/60Hz or 625i/50Hz interlace signals. • Some DVD player terminals may be labeled differently: Connect To (on the DVD player) Y(green) Y Cb (blue) Cb, Pb, Cb or B-Y Cr (red) Cr, Pr, Cr or R-Y If you select "DVD" on your TV screen, the signal from the T (monitor output) jacks will not be output properly. This does not indicate a malfunction. Additional Information 23 ■ Troubleshooting If you find any problem while viewing your TV, you can either use the Reset function or check the Troubleshooting guide below. If the problem persists, Reset function Press the RESET button on your remote control. Your TV will go blank for a few seconds then the "Initial Setup” menu will appear. Pressing RESET will set your TV to the factory setting, but certain problems may be solved. Troubleshooting guide contact your Sony dealer. RESET RESET -© w л # m О о о SONY Symptom Possible cause Solutions Page Snowy picture • The connection is loose or the cable is damaged. • Check the antenna cable and connection on the TV, VCR and at the wall. 22 • The antenna setup is inappropriate. • Check the antenna setup. Contact a Sony dealer for advice. - Noisy □d sound • Channel presetting is inappropriate or incomplete. • Display the "Channel Setup” menu and select "Manual Program” to preset the channel again. 20 • Signal transmission is low. • Try using a booster. - Distorted picture • Broadcast signals are too strong. • Turn off or disconnect the booster if it is in use. Noisy □0 sound //, Good picture • The TV system setting is inappropriate. • Display the "Channel Setup” menu and select the appropriate "TV System”. 20 Noisy sound DCS 24 Additional information Symptom Possible cause Solutions Page No picture • The power cord, • Check the power cord, antenna and VCR 22 antenna or VCR is not connected. connections. • The TV is not turned on. • Press 1/1 (power). • Press ® (main power) on the TV to turn off the TV for about five seconds, then turn it on again. 9 No sound tt]X 8 Good picture • The volume level is too low. • Press 2 + to increase the volume level. 9 É! • The sound is muted. • Press to cancel the muting. 9 No sound □ÛX Dotted lines or stripes • There is local interference from cars, • Do not use a hair dryer or other equipment near the TV. - li © iii neon signs, hair dryers, power generators, etc. • Check the antenna setup. Contact a Sony dealer for advice. - _ Double images or "ghosts" • Broadcast signals are reflected by nearby mountains or • Use a highly directional antenna. • Use the fine tuning ("Fine") function. 20 buildings. • The antenna setup is inappropriate. • Check the antenna setup. Contact a Sony dealer for advice. - • Use of a booster is inappropriate. • Turn off or disconnect the booster if it is in use. - No color • The color level setting is too low. • Display the "Picture" menu and select "Personal" of "Mode", then adjust the "Color" level in "Picture Adjustment". 15 • The color system setting is inappropriate. • Display the "Setup" menu and check the "Color System" setting (usually set this to "Auto"). 21 • The antenna setup is inappropriate. • Check the antenna setup. Contact a Sony dealer for advice. - continue Additional Information 25 continued Symptom Possible cause Solutions Page Picture slant • The magnetic disturbance from external speakers or other equipment, or the direction of the earth's magnetic field may affect the TV. • Keep external speakers or other electrical equipment away from the TV. • Display the "Setup" menu and adjust "Picture Rotation" so that the picture position is optimal. 21 Abnormal color patches • The magnetic disturbance from external speakers or other equipment, or the direction of the earth's magnetic field may affect the TV. • Keep external speakers or other equipment away from the TV. Do not move the TV while the TV is turned on. Press ® (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. The 1 (standby) indicator on your TV flashes red several times after every three seconds. • Your TV's self-diagnosis function indicates the possible problems. • Count the number of times the 1 (standby) indicator flashes. Press ® (main power) to turn off your TV. Contact your nearest Sony service center. TV cabinet creaks. • Changes in room temperature sometimes make the TV cabinet expand or contract, causing a noise. This does not indicate a malfunction. — - A small “boom” sound is heard when the TV is turned on. • The TV's demagnetizing function is working. This does not indicate a malfunction. — - 26 Additional Information ■ Specifications KV-XR29M80 Note Power requirements 110-240 V AC, 50/60 Hz Power consumption (W) Indicated on the rear of the TV Television system B/G, I, D/K, M Color system PAL, PAL 60, SECAM, NTSC3.58, NTSC4.43 ...