Votos - 5, Puntuación media: 4
(
)
)
|
Resumen del manual
• To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. • Programming channels when the antenna input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly. To program channels automatically: 1 Configure the antenna input source, if you have not already done so (-page 39). 2 Press Y and open the Setup menu. 3 Highlight Installation and press T. Setup Installation CE-Link Setup Sleep Timer HDMI Settings PC Settings Blue LED Illumination High Power-On Mode Power-Saving 4 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Program to bring up the Start, and press T again to begin channel programming. Channel Tuning Mode Standard Signal Meter Installation Terrestrial Input Configuration Channel Program Channel Add/Delete Start ANT Cable Scanning channels, please wait ... Number of Channels Found - 73 Scanning Digital Channels Found Channel - 118 Abort 52% The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears (as shown above). 5 To cancel channel programming, press O on the remote control (or highlight Abort in the on-screen display and press T). When channel programming is finished, press
TV - 46RF350U (3.69 mb)
TV - 40RF350U (3.69 mb)
TV - 46RF350U (3.69 mb)