Votos - 3, Puntuación media: 3 ( )

Fabricar: Toshiba Tamaño del archivo: 3.53 mb Nombre del archivo: Idioma del manual:

• TV Auto Input Switch: On/Off • TV Auto Power: On/Off • Device Auto Standby: On/Off • Speaker Preference: TV Speakers/Audio Receiver 5 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T. Using the HDMI settings feature This menu consists of the following 2 items (new HDMI capabilities) and will be grayed out on non-HDMI inputs. Some HDMI legacy sources may not work properly with your HDMI TV, please try setting the following options (Lip-Sync Latency and Deep Color) to Off. Adjusting these settings should allow your HDMI legacy source to operate properly with your TV. Note: You must disconnect your source device first before settings can be adjusted. • Lip-Sync Latency: On This option activates an auto audio/video display timing adjustment function that allows HDMI source devices to accurately perform synchronization automatically. • Deep Color: On (46” and 52” models only) This feature allows the HDMI source to increase available colors bits within the boundaries defined by the RGB or YCbCr color space. All above HDMI settings need proper HDMI source device. If HDMI source products does not support these features, the TV may not work properly by activating these features. Note: If your HDMI connection is capable of 1080p and/or your TV is capable of refresh rates greater than 60Hz or supports Deep Color, you will need a Category 2 cable. Conventional HDMI/DVI cables may not work properly with this mode. To set the HDMI Settings: 1 Select the appropriate HDMI input mode (HDMI 1, HDMI 2, HDMI 3, or HDMI 4). 2 From the Setup menu, highlight HDMI Settings and press T. 3 Press B or b to highlight the item you want to set. 4 Press C or c to select On or Off . 5 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T. Chapter 6: Using the TV’s features Chapter 6: Using the TV’s features Displaying TV status information To display TV status information using RECALL: Press Eon the remote control. The following information will display (if applicable): • Current input (ANT/CABLE, Video 1, etc.) • If ANT/CABLE is the current input, either “CABLE” (for cable TV) or “ANT” (for over-the-air broadcasts). • Channel number (if in ANT/CABLE mode) • Channel label (if set) • Digital signal strength indicator (bar graph in lower right corner of box; for ATSC signal only) • Stereo, Mono or SAP audio status (when HDMI input mode, Dolby Digital or PCM) • Video resolution • Aspect ratio of incoming video signal (4:3 or 16:9) • V-Chip rating status • GameTimer (if set) 2-2 ANT WEATHER Stereo None480i 4:3 To close the RECALL screen: Press Eagain. To display TV status information using INFO: (only available for ANT/CABLE input) Press Q on the remote control. The following additional information will display for off air digital channels (if applicable): • Title • D...

Descargar ahora

Introduzca dos números de la imagen: