Votos - 3, Puntuación media: 4 ( )

Fabricar: Sony Tamaño del archivo: 3.21 mb Nombre del archivo: Idioma del manual:

2 Press 1 on the TV. The = (power) indicator will light up in green. When you switch on the TV for the first time, the Language menu appears on the screen. ~ • When you turn on the TV for the first time, the TV requires some internal processing for optimization before you can perform the initial setup. There will be no picture and sound, and the timer indicator on the front of the TV blinks orange for about 40 seconds. Do not turn off the TV during this process. This process has been completed at the factory for some TVs. Follow the instructions on the screen. Satellite Auto Tuning: The following procedures may be required depending on the area: 1 Please select “Preferred Satellite” or “General Satellite”. 2 For “Preferred Satellite”, select your preferred operator. “Satellite Auto Tuning” automatically tunes in available satellite channels. Digital Satellite Equipment Control (DiSEqC) 1.0 management allows setting of up to four different channels. The following settings are independent for each connection. To set-up DiSEqC input in the “DiSEqC Control”, use “LNB Configuration”. 1 “Scan Type” and “Advanced Settings” (for common satellite setting- Satellite 1 to 4): Allows you to set tuning settings in more detail to better find the type of services you would prefer to tune. “Scan Type”: If no channel is found using “Network Scan”, try “Full Scan”. “Full Scan”: Performs a complete frequency scan and guarantees tuning to all possible programmes for the currently set LNB configuration. Previously-tuned programmes will be lost. “Network Scan”: Performs a scan in the transponders of a network (aka NIT scan). Since “Network Scan” is faster than “Full Scan”, it is recommended when tuning to a known network (normally associated with a satellite). A transponder must be specified, from which network information (other transponders) will be retrieved. Previously-tuned programmes will be lost. 2 “LNB Configuration” (for each satellite setting- Satellite 1 to 4): In the case of a non-standard LNB (lownoise block), manual setting is available. – In the case of a single satellite channel, you can leave it on the initial setting. – For two satellite channels, you need to set “Toneburst A” (1st satellite) and “Toneburst B” (2nd satellite) in the “DiSEqC Control” setting. 14 GB – – – For four satellite channels, DiSEqC control A, B, C, and D is required. “LNB Low Band Frequency” and “LNB High Band Frequency”: – Specifies LNB frequency bands. Be sure to check your LNB documentation to set frequencies (normally appears as “L.O. frequency”). – The default values are for a universal LNB. – If your LNB can handle both bands (low and high), you can specify both. If it handles only one, specify low band. “22 kHz Tone”: If your LNB is dual band (low and high bands), set to “Auto”. The TV will take care of everything automatically; otherwise, set to “Off”. “LNB Voltage”: Specifies the set voltage for a dual polarisation LNB. – 13/18V: default. – 14/19V: if LNB cable is ove...

Descargar ahora

Introduzca dos números de la imagen: